Makita BFL300F Інструкція з експлуатації - Сторінка 11

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Електроінструмент Makita BFL300F. Makita BFL300F 17 сторінок. Cordless angle screwdriver
Також для Makita BFL300F: Технічна інформація (13 сторінок), Інструкція з експлуатації (13 сторінок), Інструкція з експлуатації (10 сторінок)

ASSEMBLY

1. Socket

2. Hole

3. Pin

OPERATION

CAUTION:

•

Always be sure that the tool is switched off and the

battery cartridge is removed before carrying out any

work on the tool.

Selecting correct socket

There are different types of sockets for some models

depending on applications. Choose and install a correct

socket for your application.

Installing or removing socket

005742

To install the socket, push it onto the square drive of the tool

with one hand by depressing a pin on the square drive with

another hand until it locks into place. To remove the socket,

simply pull it off depressing the pin on the square drive.

Hold the tool firmly and place the socket over the bolt or nut.

Then switch the tool on. When the clutch cuts in, the motor

will stop automatically. Then release the switch trigger.

NOTE:

•

Hold the tool with its square drive pointed straight at the

bolt or nut, or the bolt or nut will be damaged.

•

Use of a low temperature conditioned battery cartridge

may sometimes give warning for battery cartridge

capacity by warning lamp and beeper which makes the

tool stop immediately. In this case, the range of fastening

capacity may be inferior to those shown in the above

even if a charged battery cartridge is used.