Makita BFL400F Інструкція з експлуатації - Сторінка 9
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Електроінструмент Makita BFL400F. Makita BFL400F 17 сторінок. Cordless angle screwdriver
Також для Makita BFL400F: Технічна інформація (13 сторінок), Інструкція з експлуатації (13 сторінок), Інструкція з експлуатації (10 сторінок)
Друкувати сторінку
Function
Auto-stop
This function works when the tool
fastening
has reached the preset fastening
torque and normal tightening has
been completed. This helps
overtightening to be avoided.
Delayed re-start
For approximately one second
after auto-stop fastening, the tool
does not start even if the switch
trigger is pulled.
Warning against
Insufficient fastening has been
insufficient
performed when the switch
fastening
trigger has released before
reaching the preset fastening
torque.
Warning for
This indicates the appropriate
battery cartridge
time to replace the battery
capacity
cartridge when the battery power
becomes low.
Checking the
This function works when the
remaining battery
battery power is almost used up.
capacity,
At this time, tool stops
Autostop
immediately.
Check the LED
This function works to check the
indicator, light
proper operation of the LED
and beeper
indicator, light and beeper when
operation
a battery cartridge has been
inserted into the tool.
This function works when an
Anti-reset of
abnormal drop of the battery
controller
voltage occurs for some reason,
and the tool stops.
This function works if the
Overheat
temperature of the controller or
motor increases to a high level
and the tool stops.
This function works to avoid the
Operation error of
tool's immediate start upon
the switch trigger
insertion of battery cartridge into
the tool with the switch trigger
being pulled.
This indicates the abnormal
Motor malfunction
condition of the motor. The tool
does not operate.
LED indicator / Beeper
Led indicator / Beeper on the tool shows the following func-
tions.
Status
Lights up in green
for approximately
one second.
Lights up in red.
Flickers in red
slowly.
Lights up in red.
Lights up first in
green, next red.
(And then the light
comes on.)
Flickers in red and
green alternatively.
Flickers in red
quickly.
Flickers in red and
green alternatively.
Flickers in red and
green
alternatively.
Status of the LED indicator/beeper
LED indicator
A long beep
A series of long
beeps
A long beep
A series of very
short beeps
A series of short
beeps
A series of short
beeps
A series of short
beeps
A series of short
beeps
Action to be taken
Beeper
–
Retighten the screw
Replace the battery
with fully charged
one
Replace the battery
with fully charged
one
Replace the battery
with fully charged
one
Remove the battery
cartridge
immediately and
cool the tool down.
Release the switch
trigger.
Ask Makita service
centers.
003814
–
–
9