Avanti FF18D1B Посібник з монтажу - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник з монтажу для Холодильник Avanti FF18D1B. Avanti FF18D1B 12 сторінок. Icemaker installation

Adjust the leveling bracket to ensure the ice maker

assembly is totally level.

The ice maker will be level when the gap between the

freezer wall and the ice maker assembly is the same at the

top and bottom.

Once completely level, tighten the leveling bracket screw.

Reinstall the freezer shelf below the ice maker assembly.

Set the ice container below the ice maker assembly.

Locate the factory punched holes at the lower right panel

on the rear of the refrigerator.

Align the water valve with the holes and secure the water

valve in place with the four (4) Phillips Head Self-Tapping

screws and a power drive with the Phillips Head bit.

Connect the wiring harness to the water valve as shown.

Ensure the connection is secure.

Push the plastic water supply tube into the bottom of the

water valve as far as it will go.

Tighten the Nylon compression nut by hand to the water

valve.

Then tighten the nut until it is secure but DO NOT

overtighten using a wrench.

Secure the plastic water tubing to the rear of the

refrigerator cabinet with the two (2) plastic clamps

provided.

** NOTE **

Clean the area of the back of the unit where you will be

placing the plastic clamp with household cleaner, ammonia

or alcohol to provide a clean surface for the adhesive to

adhere to.