Makita BHR241 Технічна інформація - Сторінка 9
Переглянути онлайн або завантажити pdf Технічна інформація для Електроінструмент Makita BHR241. Makita BHR241 14 сторінок. Cordless combination hammer
Також для Makita BHR241: Технічна інформація (14 сторінок)
Друкувати сторінку
R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -8. Swash Bearing Section (cont.)
DISASSEMBLING
6) Move Piston cylinder to the rear dead center position (Fig. 32).
7) Remove Swash bearing section from Inner housing by pulling in the direction of the arrow. Then, remove Change plate
from the groove of Clutch cam. (Fig. 33).
Fig. 32
Piston
cylinder
Swash bearing section
8) Remove Ball bearing 606ZZ from Gear housing complete using the removed Swash bearing section as a jig as follows;
* Insert Cam shaft of Swash bearing section into the Ball bearing again.
* Tilt the Ball bearing a little bit by moving Swash bearing section as illustrated to left in Fig. 34.
* Ball bearing 606ZZ can now be removed by lightly tapping the edge of Gear housing complete with plastic
hammer as illustrated to right in Fig. 34.
Fig. 34
9) Remove Ring 8 using 1R022, 1R023, 1R281 and arbor press as illustrated in Fig. 35.
10) Remove Ball bearing 608ZZ using 1R269. Flat washer 8 and Bearing retainer can now be removed by hand. (Fig. 36)
Fig. 35
Ring 8
1R022
1R022
1R023
Piston cylinder
in the rear dead center position
Gear housing
complete
Swash bearing section
used as a jig
1R281
Ball bearing
608ZZ
Fig. 33
Swash bearing section
Ball bearing 606ZZ
Fig. 36
Ball bearing 608ZZ
Ring 8
Inner housing complete
Change plate
Change plate
Clutch cam
1R269
Bearing retainer
Flat washer 8
P 9/ 14