Makita BJR182Z Технічна інформація - Сторінка 3

Переглянути онлайн або завантажити pdf Технічна інформація для Електроінструмент Makita BJR182Z. Makita BJR182Z 11 сторінок.

Друкувати сторінку

epair

[3] DISASSEMBLY/ASSEMBLY

[3] -1. Blade Clamp Section

DISASSEMBLING

1) Remove Shoe. If the Blade clamp section is positioned inside

Gear housing, pull it out of Gear housing. (Fig. 2)

2) After removing Protector, remove Retaining ring S-18 using 1R291.

Then remove the following parts:

Driving sleeve, Shoulder pin 5, Compression spring 6,

Pin 3 (of 6mm length), Guide sleeve, Driving sleeve guide

Now Sleeve can now be seen. (Fig. 3)

Fig. 3

Protector

Retaining ring S-18

3) Sleeve is still locked at this

stage. Therefore, release it

using a recipro saw blade

as illustrated in Fig. 4.

4) While putting your finger on the top of Slider to close the slit of Slider, remove Pin 3 (of 19.8mm length) by pushing

with a thin bar. (Fig. 5)

Note: Be sure to put your finger on the top of Slider or Push plate will pop out from the slit of Slider.

5) Remove Sleeve and Torsion spring 17 from Slider, then take Push plate and Compression spring 2 out of the slit of

Slider. (Fig. 6)

Fig. 5

Pin 3, 19.8mm long

Driving sleeve

(of 6mm length)

Fig. 4

[Sleeve Locked]

Recipro saw blade

Pin 3, 19.8mm long

Sleeve

groove

Fig. 6

Slider

Sleeve

thin bar

Torsion

spring 17

Sleeve

Slider

Fig. 2

Shoe

Pin 3

Guide sleeve

Sleeve

[Sleeve Released]

Push the recipro saw blade.

Now sleeve can rotate.

Pin 3 is positioned at

the lower end of the

groove on Sleeve

when Sleeve is released.

Push plate

Compression

spring 2

P 3/11

Blade clamp section

Shoulder pin 5

Compression spring 6

Driving sleeve guide