Makita BJS100 Технічна інформація - Сторінка 7
Переглянути онлайн або завантажити pdf Технічна інформація для Електроінструмент Makita BJS100. Makita BJS100 9 сторінок. Cordless metal shears 1.0mm (20ga)
Також для Makita BJS100: Інструкція з експлуатації (8 сторінок), Інструкція з експлуатації (12 сторінок)
Друкувати сторінку
R
epair
[4] ADJUSTMENT
Adjustment of Blade Clearance
The blade clearance between Center blade and each of the two Side blades should be 0.2mm.
If the clearance is not correct, adjust it to 0.2mm using Feeler gauge set (No.1R366) as described in Fig. 14.
Fig. 14
1) Loosen M6x10 Hex socket set screw
by turning it counterclockwise
about one turn with Hex wrench 3.
Note: Do not remove this screw.
2) Insert 0.2mm leaf of Feeler gauge set (No.1R366) into the clearance A, and insert 0.05mm leaf and
0.15mm leaf into the clearance B.
Feeler gauge leaf to insert into the clearance
Leaf thickness: mm
Side blade L
Clearance A
3) Turn M4x25 Hex socket head bolt with Hex wrench 3 until each clearance is adjusted to 0.2mm.
Hex wrench 3
M4x25 Hex socket head bolt
(located on the side of
Side blade L)
4) After adjusting the clearance, remove leaves of Feeler gauge, then tighten M6x10 Hex socket set screw
by turning it clockwise with Hex wrench 3.
Clearance A
Clearance B
0.2
0.05 + 0.15
Center blade
Side blade R
Clearance B
0.2mm Feeler gauge leaf
Hex wrench 3
Clearance A
Feeler gauge set (No.1R366)
Side blade L
Side blade R
Center blade
0.05mm Feeler gauge leaf
plus
0.15mm Feeler gauge leaf
P 7/ 9
M6x10 Hex socket set screw
(located on the side of
Side blade R)
Clearance B