Makita BTL060Z Технічна інформація - Сторінка 9

Переглянути онлайн або завантажити pdf Технічна інформація для Електроінструмент Makita BTL060Z. Makita BTL060Z 9 сторінок. Cordless angle impact drivers 14.4v/ 18v

Друкувати сторінку

iring diagram

[3] Before Connecting Switch to LED Circuit

Fig. D-4

Lead wire holder

Fix Lead wires with Lead wire holder.

Do not cross Lead wires under Switch.

Note: Be careful not to pinch Lead wires between

Switch and the inside wall of Housing L.

Pass Lead wires through the grooves.

Route Lead wires in this space.

Note: Be careful not to put Lead wires on the rib.

Connect Flag connectors with Terminal and Switch

as illustrated to right.

[3] After Connecting Switch to LED Circuit

Fig. D-5

Put Connectors on Lead wires.

Put the slack portion of LED Circuit lead wires in this space.

Pass Lead wires between the pin and the inside wall of Housing L.

Put the slack portion of Switch lead wires in this space.

Note: Be careful not to put Lead wires on the rib.

Also be careful not to allow Lead wires to contact the edge

of DC Motor or Terminal of DC Motor.

groove

Switch

rib

Switch

Housing L

DC Motor

Terminal

Flag connector

pole mark (+)

pole mark (-)

DC Motor

Connector

Terminal of DC Motor

P 9/ 9

red

Switch

black

M1 M2