Makita BTW070 Інструкція з експлуатації - Сторінка 7
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Електроінструмент Makita BTW070. Makita BTW070 12 сторінок.
Також для Makita BTW070: Технічна інформація (6 сторінок), Інструкція з експлуатації (16 сторінок)
Друкувати сторінку
OPERATION
Standard bolt
N.m
(kgf.cm)
120
(1224)
100
(1020)
80
(812)
60
(612)
40
(408)
20
(204)
0
1.0
2.0
3.0
Fastening time
High tensile bolt
N.m
(kgf.cm)
60
(612)
50
(510)
M8
40
(408)
30
(306)
20
M6
(204)
10
(102)
0
1.0
2.0
Fastening time
CAUTION:
•
Hold the tool firmly and place the socket over the bolt or nut. Turn the tool
on and fasten for the proper fastening time and number of impacts
(presetting number).
•
If the tool is operated continuously until the battery cartridge has
discharged, allow the tool to rest for 15 minutes before proceeding with a
fresh battery.
The proper fastening torque may differ depending upon the kind or size of the
005766
bolt, the material of the workpiece to be fastened, etc. The relation between
fastening torque and fastening time is shown in the figures.
NOTE:
•
When fastening screw M8 or smaller, carefully adjust pressure on the
switch trigger so that the screw is not damaged.
M12
•
Hold the tool pointed straight at the bolt or nut without applying excessive
(M12)
pressure on the tool.
M10
•
Excessive fastening torque may damage the bolt/nut or socket. Before
starting your job, always perform a test operation to determine the proper
(M10)
M8
fastening time for your bolt or nut. Especially for the bolt smaller than M8,
perform the above test operation to prevent the trouble on socket or bolt,
etc.
(M8)
•
If the tool is operated continuously until the battery cartridge has
discharged, allow the tool to rest for 15 minutes before proceeding with a
4.0
5.0
(S)
fresh battery cartridge.
The fastening torque is affected by a wide variety of factors including the fol-
lowing. After fastening, always check the torque with a torque wrench.
1.
When the battery cartridge is discharged almost completely, voltage will
005767
drop and the fastening torque will be reduced.
2.
Socket
•
•
M10
(M10)
3.
Bolt
•
(M8)
•
(M6)
4.
The use of the universal joint or the extension bar somewhat reduces the
3.0
fastening force of the impact wrench. Compensate by fastening for a
(S)
longer period of time.
5.
The manner of holding the tool or the material of driving position to be
fastened will affect the torque.
6.
Operating the tool at low speed will cause a reduction in the fastening
torque.
Failure to use the correct size socket will cause a reduction in the
fastening torque.
A worn socket (wear on the hex end or square end) will cause a
reduction in the fastening torque.
Even though the torque coefficient and the class of bolt are the
same, the proper fastening torque will differ according to the
diameter of bolt.
Even though the diameters of bolts are the same, the proper
fastening torque will differ according to the torque coefficient, the
class of bolt and the bolt length.
7