Garde 181COM1NBMA Посібник із швидкого старту - Сторінка 2
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Відкривачка для консервів Garde 181COM1NBMA. Garde 181COM1NBMA 2 сторінки. Heavy-duty #10 can opener
Друкувати сторінкуThe can opener's surface and knife should be cleaned regularly using a food safe sanitizer.
Recommendation: Noble Chemical's QuikSan Sanitizer and Disinfectant (147QUIKSAN)
Use a toothbrush-style brush to ensure you are able to reach the crevices around the knife.
Recommendation: Scrubble Products 7¼" Utility Brush with Stainless Steel Bristles (27140675)
After cleaning, apply a food safe oil to the gear to keep it turning smoothly.
Recommendation: Petrol-Gel Food Grade Sanitary Lubricant - 4 oz. Tube (401PETROGEL)
Replacing The Knife
(181CO1KNIFMA)
1. Using either a Phillips or flat
head screw driver, remove the 2
screws that connect the knife to
the opener.
2. Remove and discard the old
knife while keeping the knife
support plate.
3. Position the new knife in line
with the holes and place the
support plate on top of the knife.
4. Use the screwdriver to tighten
the screws.
It is recommended the knife and gear are replaced at the same time for optimal performance
Replacement parts can be purchased from the same location
Plated Steel Base
181BASE1PSMA
Stainless Steel Base
181BASE1SSMA
Knife
181CO1KNIFMA
This can opener is guaranteed to be free of defects in materials and workmanship for the
period of 1 Year. The warranty does not cover the knife and gear. The warranty does not
cover failure due to neglect, misuse or improper handling. The warranty does not apply to
any use of or sale of the product outside of the United States.
Cleaning/Maintenance
1. Insert the can opener into the base. The base will be needed
for leverage while removing the gear.
2. Use a flat head screw driver to hold the gear in place by
jamming the head of the screw driver into the teeth of the
old gear. You will need to apply enough pressure to hold the
gear in place.
3. With the screw driver in place, begin turning the handle
counter clockwise. You should feel the tension in the spring
ease up and the gear will come loose after a few turns.
4. Remove the old gear and keep the washer. Insert the new
gear with the washer on top. Turn the handle clockwise until
the handle connects to the shaft below the gear. The spring
should be tense now and the can opener ready to use.
Replacement Parts
the can opener was purchased.
Knife & Gear Kit
181COM1KITMA
Knife Support
181COM1SUPMA
Screw Set
181CO1SCRWMA
Warranty
Replacing The Gear
(181CO1GEARMA)
181CO1GEARMA
181CO1WASHMA
Gear
Washer