HIKVISION DS-9104HFI-ST series Короткий посібник з експлуатації - Сторінка 4

Переглянути онлайн або завантажити pdf Короткий посібник з експлуатації для ВІДЕОРЕЄСТРАТОР HIKVISION DS-9104HFI-ST series. HIKVISION DS-9104HFI-ST series 19 сторінок. Ds-9100hfi-st series

Друкувати сторінку
Quick Operation Guide of DS-9100HFI-ST Series DVR

Front Panel

No.
Name
ALARM
READY
STATUS
HDD
1
MODEM
TX/RX
GUARD
2
IR Receiver
3
Front Panel Lock
DVD-ROM
4
5
Alphanumeric Buttons
6
USB Interfaces
ESC
REC/SHOT
7
PLAY/AUTO
Function Description
Alarm indicator turns red when a sensor alarm is detected.
Ready indicator is normally green, indicating that the DVR is functioning
properly.
Status indicator turns green when DVR is controlled by an IR remote.
Indicator turns red when controlled by a keyboard and purple when IR
remote and keyboard is used at the same time.
HDD indicator blinks red when data is being read from or written to HDD.
Reserved for future usage.
TX/RX indictor blinks green when network connection is functioning
properly.
Guard indicator turns green when the device is in armed status; at this time,
an alarm is enabled when an event is detected. The indicator turns off when
the device is unarmed. The arm/disarm status can be changed by pressing
and holding on the ESC button for more than 3 seconds in live view mode.
Receiver for IR remote
You can lock or unlock the panel by the key.
Slot for DVD-ROM. (Optional)
•
Switching to the corresponding channel in Live view or PTZ Control
mode.
•
Inputting numbers and characters in Edit mode.
•
Switching between different channels in Playback mode.
•
The light of the button is green when the corresponding channel is
recording; it is red when the channel is in network transmission status; it is
pink when the channel is recording and transmitting.
Universal Serial Bus (USB) ports for additional devices such as USB mouse
and USB Hard Disk Drive (HDD).
Back to the previous menu
Pressing for Arming/disarming the DVR in Live View mode.
Entering the Manual Record setting menu. In PTZ control settings, press the
REC/SHOT button and then you can call a PTZ preset by pressing Numeric
button.
The PLAY/AUTO button is used to enter the Playback menu. It is also used
to turn audio on/off in the Playback menu and auto scan in the PTZ Control
menu.
3