Garden Architecture HERITAGE PERGOLA ARBOR Інструкція з монтажу - Сторінка 3
Переглянути онлайн або завантажити pdf Інструкція з монтажу для Меблі для вулиці Garden Architecture HERITAGE PERGOLA ARBOR. Garden Architecture HERITAGE PERGOLA ARBOR 4 сторінки.
Друкувати сторінкуGARDEN STRUCTURES
HERITAGE PERGOLA ARBOR
STEP 3
•
Carefully raise and square up the arbor. This can be easily done with a large carpenter's square, a tape meas-
ure, or even a length of string, as shown below.
With a square:
pencil
mark
carpenter's
square
STEP 4
•
Center one of the cap pieces across
the two headers, placing it between
the two marks. Fasten with a 1¼"
screw through hole centered into
top of one header. Secure cap to
second header in same manner.
•
Using spacer provided, attach other
cap pieces at equal intervals, 3 caps
on each side of the center one.
•
Assembly is complete. Carefully
raise arbor upright. Anchoring steps
are on next page.
Product ID 820.2170 / Instruction ID 445.35.30
Bowers Forest Products / PO Box 589 / Beavercreek, OR 97004 / Cust. Serv. 503-631-4408
ASSEMBLY INSTRUCTIONS
With a tape measure or string:
"a"
"x
"y"
"b"
1. Measure the distance "a" at post tops.
2. Set bottom of posts to same spacing "b".
3. Measure diagonal distance "x".
4. Check opposite diagonal distance "y".
When a=b and x=y, the arbor is square.
•
When the arbor is squared up, drive two 1¼"
screws at the top of each brace into the header.
.
Spacer
Updated 11/19/19