Avanti WD50 Інструкція з експлуатації - Сторінка 7
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Диспенсер для води Avanti WD50. Avanti WD50 15 сторінок.
Також для Avanti WD50: Інструкція з експлуатації (15 сторінок)
Друкувати сторінку•
Fill water tank with tap water full to capacity (almost 3/4 of a gallon). Wait for 5
minutes until water settles.
•
Press the hot water faucet until water comes out, then stop.
•
Plug the dispenser into the electrical outlet. All three indicator lights on front will
light up at first. We are ready to complete the first cycle. In order to do that, wait
for the hot water indicator light to go off first (approximately 10 minutes), then wait
for the cold water indicator light to go off (another 5 minutes, approximately).
•
Unplug the dispenser from the electrical outlet. Proceed to drain the water from
the faucets one at a time until no more water remains.
(Note: To facilitate this operation, use a large container).
•
Then, drain any water left in the tanks by opening the drain caps located on the
back, one at a time. First the one marked "hot" until it drains completely. Then the
one marked "cold".
•
Proceed to close both drain caps. Also make sure both faucets are in the off
position.
•
Place the 5 gallon bottle of water on the water intake, allow water to stand for
approximately one minute.
•
Turn on water faucets to insure water flows from both faucets.
•
Plug dispenser into the electrical outlet.
•
Now you are ready to use your water dispenser.
NOTE: Your water dispenser has been cleaned and sanitized before leaving the
factory, but in case a taste problem develops, place one tablespoon of
baking soda and add tap water. Fill water tank again and repeat basic
operations previously outlined, except turn the switch market hot "OFF" to
avoid leaving residues in hot water tank.
ATTENTION:
If you do not plan to use the water heating function for more than three days, we
recommend that you turn the hot water switch to "OFF" position.
IMPROPER USE OF THE GROUNDED PLUG CAN RESULT IN THE RISK OF ELECTRICAL SHOCK. IF
THE POWER CORD IS DAMAGED, HAVE IT REPLACED BY AN AUTHORIZED AVANTI PRODUCTS
SERVICE CENTER.
Steps to replace water bottles
Use a clean cloth to wipe off neck of bottle.
Remove cap.
Carefully lift bottle (approx. 40 lbs.) using your legs and not your back. Do not place hands in
opening of bottle while placing in reservoir.
Insert the water bottle on the water intake over reservoir opening so it settles properly on it.
Wipe off any water which may have splashed on dispenser top.
Cold Water Control
Turn the cold-water switch (12) on. The green indicator will be lit and the process begins. When the
water reaches the right temperature the green light goes off automatically.
Hot Water Control
Turn hot water switch (13) on, the red indicator will be lit and the unit will begin to heat the water.
When the water reaches the right temperature the red light goes off automatically.
WARNING
OPERATING YOUR WATER DISPENSER
7
When the