Avanti WDT51 Інструкція з експлуатації - Сторінка 8

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Диспенсер для води Avanti WDT51. Avanti WDT51 15 сторінок.
Також для Avanti WDT51: Інструкція з експлуатації (15 сторінок)

temperature goes down to approx. 80º C (176º F), the red indicator will glow again and another heating
process starts.
NOTE:
THE HOT WATER FAUCET HAS A CHILD-SAFETY GUARD ATTACHMENT.
To get hot water:
Squeeze safety valve on backside of handle and tilt faucet handle down.
Continue holding safety valve while pushing down faucet handle as long as water is being
dispensed.
When faucet handle is released, make sure to return it to the original position until a click is
heard.
Cup Dispenser (Optional)
A cup dispenser may be installed by using the mounting holes (covered with plastic caps) located near
the top of the right side panel of the cooler. The cup dispenser comes equipped with a mounting
bracket and screws and may be ordered by completing the enclosed order form provided with your
instruction manual.
Wash the inside of the reservoir with a warm water and baking soda solution. The solution should
be about 2 tablespoons of baking soda to a quart of water.
The drip tray and water faucets should be cleaned with mild detergent and warm water.
At regular intervals or once a month inspect the coils located across the back of the dispenser.
Vacuum accumulation of dust or clean it with a hard brush.
If the water dispenser will not be used for a long period of time, unplug the power cord from the
wall outlet.
Drain the water through the faucets.
Turn the switch market hot to the "OFF" position.
Drain the water from the tanks by removing the plugs from the back of the dispenser.
WARNING—THE WATER COMING OUT OF THE BACK SIDE MARKED "HOT" MAY BE SCOLDING.
Unit should not be transported on the sides. Place it upright if possible and cover if with a blanket.

CARE AND MAINTENANCE

TAKING DISPENSER OUT OF SERVICE
8