GARDEN MASTER GM2315 Інструкція з монтажу Посібник з монтажу
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Зберігання на відкритому повітрі GARDEN MASTER GM2315. GARDEN MASTER GM2315 8 сторінок. Sloping roof shed
Також для GARDEN MASTER GM2315: Інструкція з монтажу Посібник з монтажу (8 сторінок)
Друкувати сторінку
If you feel confident that you do not need to read through these instructions, see page 2.... January 2010
Drill and drill bits - 3.3mm (1/8th") for shed and 5mm (3/16th") for padbolt
•
Screwdriver or Riveter. (Note: all colour sheds come with rivets only)
•
Tape measure for roof overhang.
•
Ladder for fixing down thru the top of the roof.
•
Tin snips for a small nik on top channel of gable end walls only. (If applicable)
•
Non slip gloves, good shoes, goggles, a helping set of hands and no gusty winds!
•
Quick Tips to keep in mind as I build my shed:
Try to remove swarf (drill filings) from panels as I assemble them.
•
My basic job is to cap the sheeting to make the panels. Drill & Fix.
•
All components are cut to length. Do not cut any parts unless instructed.
•
They are only a phone call away 0800 807 433 or email to [email protected]
•
Fixings thru the inside of the channels into the sheeting are just as important as the outside.
•
6 x 1830 mm
Sheets for back and
roof.
1 x 740mm wide sheet with
door jamb attached
4 x 1515mm channels for End walls
2 x 2255mm channels for
the Roof
2 x 1830mm "L"s for flashing the
roof to the side walls
GM2315
2280mm W x 1530mm D x 1980 -1830mm H
ASSEMBLY INSTRUCTIONS
"
This shed has
What tools will I need?
1 x Pack of fixings with padbolt
Screws for Zincalume sheds
Rivets for Colour sheds
2 x "Z" Door braces
- Sloping Roof Shed
1 Box
and
4 x Sloping sheets for end
walls. 2 Left and 2 Right.
Door pre-hinged to
2nd 740mm sheet
with door jamb
4 x 2255mm channels with ends cut
for Front & Back walls
2 x 793mm Door
spacers
Pg 1
"
1 Channel pack