GARDEN MASTER GM2323 Інструкція з монтажу Посібник з монтажу - Сторінка 5
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Зберігання на відкритому повітрі GARDEN MASTER GM2323. GARDEN MASTER GM2323 8 сторінок. Gable roof shed
Друкувати сторінку
STEP 4:
END WALLS
1.
Join 3
sheets together to create a gable end wall as shown.
C
2.
Make a cut in the flanges only at (1145mm) the centre of the
2290mm channels.
3.
Cap the bottom of the sheets with an
2290mm channel over the top of the sheets. rivet at corners only for now.
H
4.
Slip
Gable plate under channel at the top and rivet
L
to sheeting at the *.
5.
Rivet the channels at every 2nd rib and thru gable
plate into sheeting ribs.
6.
3 rivets up underneath through
channel into pan of sheet
7.
Perform the same again
for the other end.
Channels will end 15-20mm
short at tops of end walls
and 10-15mm at bottoms.
STEP 5:
DOOR BRACES
1.
The door braces can be riveted now or after you have
assembled your shed.
2.
Tuck one end of the 'Z' between the bottom channel of the
inside of the door and the sheet. Do the same at the top,
overlapping in the centre behind the padbolt.
If you have a locking 'T' handle you will have to run the
'Z's the opposite way to the diagram.
3.
Rivet the 'Z's at the ends, and in the centre of the channel
it is tucked under, and through the overlap in the centre.
Two or three more rivets will be required through the door
sheeting into the 'Z', but they will need to be riveted through
from the outside of the door for a neater appearance.
4.
You may need to cut or bend the flange at the bottom
and the top of the 'Z' if it catches on the door jamb when
opening or closing (diagram 5).
DIAGRAM 5
before
5
!
If you choose to vary from these instructions your
warranty will be impaired.
H
2255mm channel and bend the cut
H
C
H
after
i
C
H
L
C
C
N
M
M
FREE
If you need advice, call us
or email us at [email protected]
YOU WILL NEED:
4 x sloping sheets & 2 x gable cut sheets
for ends
2 x 2255mm channels for bottom &
2 x 2290mm channels for top of end walls
2 x Gable plates for gable ends
H
L
SCAN TO
WATCH OUR
ASSEMBLY VIDEO
HERE
YOU WILL NEED:
2 x 'Z' Door braces
Rivets for Zincalume sheds
Rivets for Colour sheds
Z door braces in position on
the inside of door sheet
0800 807 433
on
ABOVE
5