AIRFUSION LD-CD52BN/WH Посібник - Сторінка 11

Переглянути онлайн або завантажити pdf Посібник для Вентилятор AIRFUSION LD-CD52BN/WH. AIRFUSION LD-CD52BN/WH 19 сторінок.

BALANCING / WOBBLYING TROUBLE SHOOTING

Please note that all ceiling fans are not the same, even in the same model—some may move more or less than

others. Movement of a couple of centimetres is quite acceptable and does not suggest the fan will fall down.

Even though all blades are weighted and grouped by weight, it is impossible to eliminate wobble altogether. This

should not be considered a fault. Ceiling fans tend to move during operation due to the fact that they are not

generally rigidly mounted

You may do the following action to reduce the wobbling

1) Check all the blade mounting screws are tightened and securely.

2) Wobbling problems may result from inconsistent blade level. To check blade level, measure the distance

from each blade tip to the ceiling.

Note: If measurements are inconsistent:

check blade mount screws are not over tightened or loose, which can cause the blade tip to not all sit

level;

An out of shape blade can cause wobbling, check by removing the blade and lay in on a flat surface. A

good flat blade will lay flat on the surface.

3) Blade tracking may be checked simply by use of a household ruler as shown in below Figure. Place the

ruler vertically against the ceiling and

even with the outside leading edge of

a blade. Note the distance of the edge

of a blade same as others. Turn the

blade slowly by hand to check the

remaining blades. If a blade is not in

alignment, the blade is either out of

shape / warped or the blade screws

are not evenly tighten or either loose.

BALANCING KIT

A Balancing Kit is provided to balance the ceiling fan on initial installation. Please refer to the instruction

on how to use the Balancing Kit, that is included

The balancing kit can be used to assist re-balancing if the ceiling fan becomes un-balanced overtime. Do

not discard the balancing kit. Retain for possible future use.

INSTALLING THE FAN

Fig. 15