Janam XP30 Посібник із швидкого старту - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Аксесуари Janam XP30. Janam XP30 7 сторінок. Xp series
Також для Janam XP30: Посібник із швидкого старту (10 сторінок), Посібник із швидкого старту (9 сторінок), Посібник із швидкого старту (15 сторінок), Посібник із швидкого старту (12 сторінок)

Installing and Charging the Battery

A. INSTALLING THE BATTERY

1. To access the battery compartment, turn the battery-screw counterclockwise to open the latch and

remove battery cover.

2. Position the battery-lift strap, place the Lithium-ion battery and snap into place.

3. Replace the battery cover* by positioning the top prongs ﬁ rst and sliding cover into place.

Tighten battery-screw by turning clockwise.

B. CHARGING THE BATTERY

Important Note: The main battery charges the backup battery in the XP Series unit. Once the main battery is fully charged, do not re-

move it from the unit for 24 hours. During this period the device cannot maintain any user data if the battery is removed.

To charge the battery using the USB Synching/Charging Cable:

a. Connect the power supply to the USB Synching/Charging cable.

b. Connect snap-on end of USB Synching/Charging cable to bottom of device making sure the word "TOP" on the

connector faces front.

c. Insert appropriate AC plug and plug in the power supply.

To charge the battery using the Single-Slot or Four-Slot Cradle:

a. Connect the power supply to the cradle.

b. Connect the line cord to the power supply.

c. Insert appropriate AC plug and plug in the power supply.

d. Place the XP device in cradle. The LED will illuminate to conﬁ rm connection (orange indicates charging, green

indicates fully charged and red indicates fault).

e. The battery is fully charged in approximately 2 hours.

f. Charge a spare battery by placing the battery in the spare battery well with label up and connectors lined up.

Janam Technologies