KitchenAid YKGRT607HW5 Інструкція з монтажу Посібник з монтажу - Сторінка 2

Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Діапазони KitchenAid YKGRT607HW5. KitchenAid YKGRT607HW5 14 сторінок. 30" freestanding and slide-in sealed burner gas range with self-cleaning thermal/convection oven

Друкувати сторінку

Before you start...

Yoursafety and the safety of others is

very important.

We have provided many important safety messages in

this manuaIand on your appliance, Always read and

obey ail safety messages,

This is the safety atert symboi. This symboi

alerts you to hazards that can kiii or hurt you

and others, Aii safety messages wiii be preceded by the

safety alert symboI and the word "DANGER"or

"WARNING", These words mean:

You ca_ be killed or seriously injured if you don't

follow instructions.

AII safety messages wilI identify the hazard,teli you

how to reduce the chance of injury, and teti you what

can happen if the instructions are not followed.

WARNING:

If the information

this manual is not followed

exactly, a fire or explosion

may

result causing property

damage, personal

injury or

death.

m Do Not store or use gasoline

or other flammable

vapors

and liquids in the vicinity of

this or any other appliance.

WHAT TO DO IF YOU SMELL

GAS

• Do Not try to light any

appliance.

• Do Not touch any electrical

switch

• Do Not use any phone in

your building.

• Immediately

call your gas

supplier from a neighbor's

phone.

Follow the gas

supplier's

instructions.

• If you cannot reach your

gas supplier, call the fire

department.

Installation

and service must

be performed

by a qualified

installer, service agency or

the gas supplier.

Countertop opening dimensions that are shown

must be used. Given dimensions provide required

clearances.

When installing a range under existing cabinets

and the installation does not meet the minimum

cabinet clearances, install a range hood above the

range to avoid burn hazards.

Read electrical and carpentry instructions.

Proper installation is your responsibility. A

qualified technician must install this range. Make

sure you have everything necessary for correct

installation. It is the customer's responsibility to

make sure that the countertop has been properly

prepared and that the installation clearances

specified on the model/serial rating plate are met.

The model/serial rating plate is located on the oven

frame behind the oven drawer.

Check location where range will be installed. The

range should be located for convenient use in the

kitchen. Recessed installations must provide

complete enclosure of the sides and rear of range.

ALL OPENINGS IN THE WALL OR FLOOR

WHERE RANGE IS TO BE INSTALLED MUST

BE SEALED.

IMPORTANT: Some cabinet and building materials

are not designed to withstand the heat produced

by the oven for baking and self-cleaning. Check

with your builder or cabinet supplier to make sure

that the materials used will not discolor, delaminate

or sustain other damage.

Panel A

Cabinet opening dimensions

25" (63.5 cm) countertop

depth

(with or without

backsplash)

and 24" (61 cm) base cabinet

depth,

36" (91.4 cm) countertop

height

Freestanding

Range

_6.7

cm)

cabinet

30"_et

clearance to

to _:ountertop

__g

width

cooktop, see

***Note

30-1/4" (76.8 cm)

opening width

I_ Jf

(7.6 cm) I

4..

I _i-9"

(22.9 cm)

4" (10 2 cm) m n

clearance from both sid

t _

of range to side wall or

•

other

combusbble

I "61 cm"

material.

,, (16.2cm)

18"

Outlet should

Gas line

located within the 18"

located within this

cm_ x 10" (46.7 cm x 26.4

shaded area.

" cm) shaded area.

2-1/2" (6.4 cm)

floor

gas line

__/

opening if directly

I _

below regulator

7/6" (2.2 cm)

min, required

between cabinet

opening and

door or hinge

opening.

Slide-in Range

4" (102cm)

min//

scj !i_oai!ifiim

t_°sthde _

combustible

material.

(22.9 cm)

3 ,I

(7,6 cm)

Gas line opening

should be located

within this shaded

floor

if directly below

regulator

30-3/8" (77.2 cm)

opening width

6 ,_

(16.

(61 cm)

Outlet should

be located

within the 18" x

10" (46.7 x 26.4

cm) shaded

area.

IMPORTANT:

Rear vent must be

installed on all slide-in

models for proper

ventilation. See Step 7,

Panel D.

7/8" (2,2 cm) min. required between

opening and door or hinge

opening.

It is the customer's responsibility:

To contact a qualified electrical installer.

To assure that the electrical installation is

adequate and in conformance with National

Electrical Code, ANSI/NFPA 70 -- latest

edition*, or CSA Standard C22.1, Canadian

Electrical Code, Part 1 -- latest edition**, and

all local codes and ordinances.

Note: This appliance is manufactured

for use

with Natural Gas. Conversion to L.P. Gas can

be made using the kit included in your

literature package.

Note: The metal chassis of the range MUST be

grounded in order for the control panel to work. If

the metal chassis of the range is not grounded, NO

keypads will operate. Check with a qualified

electrician if you are not sure the range is

grounded.

Important: Observe all governing codes and

ordinances.

Grounded electrical outlet is required. See

"Electrical requirements," Panel C.

Cabinet opening

dimensions

that are shown

must be used.

Do Not pinch the power supply cord between

the range and the wall.

Do Not seal range to side cabinets.

Copies of the standards

listed may be obtained from:

*National

Fire Protection

Association

Batterymarch

Park

Quincy, Massachusetts

02269

** Canadian

Standard

Association

178 Rexdale Boulevard

Etobicoke (Toronto),

Ontario

M9W 1R3

*** Note: 24" (61 cm) min. when bottom

of wood or

metal cabinet

is protected

by not less than 1/4"

(0.64 cm) flame retardant

millboard

covered

with not

less than No. 28 MSG sheet steel, 0.016" (0.4 mm)

stainless

steel, 0.024" (0.6 mm) aluminum

or 0.020"

(0.5 mm) copper.

30" (76.2 cm) min. clearance

between

the top of the

cooking

platform

and the bottom

of an unprotected

wood or metal cabinet.