KitchenAid Double Oven Інструкція з монтажу - Сторінка 2
Переглянути онлайн або завантажити pdf Інструкція з монтажу для Духовка. KitchenAid Double Oven. KitchenAid Double Oven 5 сторінок. Electric built-in 30” thermal single and double ovens 30” thermal convection single and double ovens
Друкувати сторінку
30" Single oven
*Note: There must be 1'
min. between
bottom
of
Before you start...
Read the electrical and carpentry instructions.
Proper installation
is your responsibility.
A
qualified technician
should install this oven. Make
sure you have everything
necessary for correct
installation.
It is the responsibility
of the installer to
comply with the installation clearances specified
on the seriaVrating plate. The serial/rating
plate
can be found behind the oven door (double oven
models -
upper oven) on the frame of the oven.
Check location
where the built-in oven will be
installed. The location should be away from strong
draft areas, such as windows, doors, and strong
heating vents. The built-in oven should be located
for convenient
use in the kitchen.
Cabinet opening dimensions
that are shown
must be used. Dimensions
given are for a built-in
oven sitting on a contact surface 2-314" below the
open oven door height. The contact surface must
be solid and level and flush with the bottom of the
cabinet opening.
The recessed installation
area
must provide
complete enclosure around the recessed portion
of the oven.
ALL OPENINGS
IN THE WALL OR FLOOR
WHERE THE BUILT-IN OVEN IS TO BE
INSTALLED
MUST BE SEALED.
Electrical ground
is required. See "Electrical
requirements."
Do Not install single oven in a base cabinet
with a countertop
above it.
I II
2-112' min.
cabinet
door
oven console.
r
See Note.*
Oven control
t-i-
_____,_
I
-w--q-
I II
and top of
I
00
Not seal
oven to
cabinets.
-.-.m.-
See Note.*
Ill
32' min. recommended
I
I
I I
so oven door, when
1
open, is 36' from floor.
===+
3!.,6"-
'
I
The oven support surface must be flush
with the bottom of the cabinet opening.
Important: Observe all governing codes
ordinances.
Electrical Shock Hazard
lt is the customer's responsibility:
l
To contact a qualified electrical installer.
l
To assure that the electrical installation
is
adequate and in conformance with
National Electrical Code, ANSUNFPA
70 - latest edition**, and all local codes
and ordinances.
Failure to do so could result in fire,
electrical shock or other personal injury.
Personal Injury Hazard
Securely fasten oven to cabinet using the
screws 4 screws provided (8 screws for
double oven).
Failure to do so could cause the oven to
move or tip during use and result in
personal injury.
30" Double oven
*Note:
There must be 1'
min. between
bottom
of
cabinet
door and top of
oven console.
Oven control
console
2-W"
min.
w;
Note
.
00 Not seal
oven to
cabinets.
I
Tools needed for
installation:
66&6'
1
opening
I
height
I
I
;'
I
68-Y8'
-
overall
height
667;16"-
recessed
oven height
II
,
See Note:
Darts supplied for
nstallation:
recommended
so
upper oven door,
when open is 36"
rews (single
crews
1
(doub e)
Panel A