Garden Sun Heater ZCV-2650 SV Посібник користувача - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник користувача для Обігрівач для внутрішнього дворика Garden Sun Heater ZCV-2650 SV. Garden Sun Heater ZCV-2650 SV 16 сторінок. Outdoor patio heater

ASSEMBLY INSTRUCTIONS
7 . Support heater. Slide three washers washer
over threaded end of spacer. Locate reflector assembly
on 3 spacers. Install three washers
securely tighten wing nuts (KK) but do not overtighten.
Hardware Used
GG
KK
Wing nut
8 . Connect hose and regulator to cylinder.
The propane gas and cylinder are sold separately.
Use a standard 20 lb. propane cylinder only.
Use this heater only with a propane vapor withdrawal
supply system. See chapter 5 of the standard for
storage and handling of liquefied petroleum gas,
ANS /NFPA 58. Your local library or fire department
should have this book.
A minimum supply pressure of 0.4 p.s.i. is required for
the purpose of input adjustment for propane gas. Storage
of an appliance indoors is permissible only if the cylinder
is disconnected and removed from the appliance. A
cylinder must be stored outdoors in a well-ventilated
area out of the reach of children. A disconnected cylinder
must have dust caps tightly installed and must not be
stored in a building, garage or any other enclosed area.
The minimum permissible gas supply pressure of 10
W.C. is required for purpose of input adjustment.
The minimum hourly of 17000 Btu is required input
rating for a heater for automatic operation at ratings less
than full input rating.
The pressure regulator and hose assembly supplied
with the appliance must be used.
The installation must conform with local codes, or in the
absence of local codes,with national fuel gas code,
ANS Z223.1/NFPA54, natural gas and propane
Installation Code, CSA B149.1, or propane storage and
handling code, B149.2.
8 on spacers and
x 6
x 3
8 (GG)
7
KK
GG
8
9
Standard 20 lb. tank