Avatar MTU-80 Посібник користувача - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник користувача для Спікери Avatar MTU-80. Avatar MTU-80 16 сторінок. Midrange speaker

Друкувати сторінку
M I X E D C O N N E C T I O N O F T H E S P E A K E R S
S E L E C T I O N O F T H E D I A M E T E R O F S P E A K E R C A B L E S
Use the table below to select the desired diameter based on the length and the power consumption.
4 . F I L T E R I N G , R E C O M M E N D E D A M P L I F I E R S E T T I N G S .
The correct choice of amplifier settings, filtering and enclosure largely influence on the lifespan of your audio
system. You should select an amplifier with a nominal power, not exceeding the nominal power of the speakers.
Proper coordination of the head unit (HU) of the amplifier will allow to get a clean, undistorted signal applied to
the component to prevent overheating and voice coil damage. The recommended HU volume is not more than
80%, input sensitivity of the amplifier is 50%.
The recommended filter settings:
The high pass filter HPF (a Filter that cuts off all frequencies below the frequency setting of the filter)
is about 80-100 Hz (24 dB/Oct), or 250-350 Hz (12 dB/Oct)
The low pass filter LPF (a Filter that cuts off all frequencies above the frequency of the filter) - 4-8
kHz (12 dB/Oct).
Recommended amplifiers: AST-2.250, AST-4.250, AST-3004
CAUTION!!! High sound pressure can damage your health!
Please use the common sense when controlling volume!
25 000
20 000
15 000
10 000
8000
6000
4000
2000
1000
500
250
100
0-1 1-2 2-3 3-4 4-5 5-6 6-7
Voice coil
4 Ohm х 4 MR
7-8
Cable length (m)
5
Total impedance
4 Ohm
Size
A.W.G mm²
5
16,8
8
8,37
10
5,26
2,08
14
EN