call waiting tone - One, two, or three beeps of high-pitched tone, not repeated; indicates an incoming call is
o
waiting to be answered. Number of beeps designates the source: 1 for an internal call, 2 for an outside or
attendant call, 3 for a priority call.
confirmation tone - Three short bursts of tone; indicates a feature activation or cancellation has been accepted.
o
coverage tone - One short burst of tone; indicates your call will be sent to another extension to be answered by
o
a covering user.
dial tone - A continuous tone; indicates dialing can begin.
o
intercept/time-out tone - An alternating high and low tone; indicates a dialing error, a denial of the service
o
requested, or a failure to dial within a preset interval (usually 10 seconds) after lifting the handset or dialing the
previous digit.
recall dial tone - Three short bursts of tone followed by a steady dial tone; indicates the feature request has
o
been accepted and dialing can begin.
reorder tone - A fast busy tone repeated 120 times a minute; indicates all trunks are busy.
o
ringback tone - A low-pitched tone repeated 15 times a minute; indicates the telephone dialed is being rung.
o
Problem
A feature does not work as
noted in the book.
The telephone does not ring.
activate
To begin or turn on the operation of a feature.
attendant
The person who handles incoming and outgoing calls at the main console.
AUDIX
Audio Information Exchange, an optional voice mail and message service that provides coverage for calls to you by recording callers' messages and reporting
Leave Word Calling messages.
call appearance button
A button used exclusively to place, receive, or hold calls. It has an assigned extension number and is equipped with a red in-use light and a green status light.
console permission
The authorization (from your system manager) to initiate Call Forwarding All Calls for an extension other than your own.
coverage
Automatic redirection of calls from an unanswered phone to another phone. Redirection could be to the extension of a receptionist, secretary, co-worker,
AUDIX, or message center. A person who provides coverage is a covering user.
dial pad
The 12 pushbuttons that you use to dial a number and access features.
enhanced list
One of the four types of Abbreviated Dialing lists; programmable only by the system manager. Contains phone numbers useful to all system members, and
stores each of those numbers as a 1-, 2-, or 3-digit list item.
extension
A dialing number of 1 to 5 digits assigned to each phone connected to your DEFINITY Communications System Generic 1 or Generic 3 switch.
feature
A special function or service, such as Conference, Hold, Send All Calls, etc.
feature code
Troubleshooting
Solution
1.
Reread the procedure and try again.
2.
For many features you must lift the handset before you can use the feature.
3.
Check with your system manager to be sure this feature is administered on your telephone.
1.
Set the ringer volume to a higher level.
2.
Place a test call from another extension to your extension.
3.
If there is still a problem, see your system manager.
Glossary
9620 IP Telephone End User Guide | 16 |
P a g e
Друкувати сторінку