Gardena 10000 SL Inox Інструкція з експлуатації Посібник з експлуатації - Сторінка 7

Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Водяний насос Gardena 10000 SL Inox. Gardena 10000 SL Inox 11 сторінок.

Друкувати сторінку

5. Cleaning

Flushing the Pump :

Cleaning the suction

base and impeller :

6. Trouble-Shooting

Problem

Pump is running,

but doesn't deliver.

Pump doesn't start or

suddenly stops during

operation.

The pumps are virtually maintenance-free.

After having pumped chlorinated swimming pool water or other

liquids leaving residues, the pump should be rinsed with clear

water.

Warning ! Electric shock !

Risk of injury due to electric shock.

V Disconnect the pump from the mains before clean-

1. Only for 10000 SL Inox : Unscrew the Phillips screw

and pull the suction base cover

2. Unscrew the 6 Phillips screws

off the pump.

3. Clean suction base

0 A

if necessary.

4. Reinstall the suction base

5. Only for 10000 SL Inox : Insert the suction base cover

the suction base

Note for 10000 SL Inox :

It is often sufficient to simply remove the suction base cover

and clean the suction base cover

For safety reasons a damaged impeller

changed by the GARDENA Service Centre.

Probable cause

Air cannot escape, since

pressure line is closed.

Air locks in the suction base.

Impeller clogged.

When starting the pump,

water height falls below the

min. water level.

Thermal overload switch has

switched the pump off due

to overheating.

ing the suction base and impeller.

, impeller

and screw in the Phillips screws

and screw in the Phillips screw

off the suction base

and pull the suction base

and suction base cover

and suction base

can only be ex-

Remedy

v Open pressure line

(e.g. kinked pressure pipe).

v Wait for max. 60 seconds

until the pump deaerates

automatically over the vent

valve. If necessary, switch

off and start it again.

v Disconnect plug and clean

impeller (see 5. Cleaning).

v Submerge pump deeper.

v Disconnect plug and clean

impeller (see 5. Cleaning).

Observe max. media temper-

ature of 35 °C.

into