Gardena 9000 aquasensor Інструкція з експлуатації Посібник з експлуатації - Сторінка 5

Друкувати сторінку

Gardena 9000 aquasensor Інструкція з експлуатації Посібник з експлуатації

Connecting the hose :

4. Operation

Automatic operation :

The universal fitting

in the previous table.

1. Cut off nipples of the universal fitting

to match the hose connection.

2. Screw the universal fitting

3. Connect the hose to the universal fitting

We recommend 38 mm (1 ¹⁄₂ " ) 25 mm (1 " ) hoses, in addition to be

fixed with a GARDENA Hose Clamps Art. No. 7192 (for 25 mm)

and Art. No. 7193 (for 38 mm).

Only for the submersible pump 7000 :

For flat suction we recommend using a 13 mm ( ¹⁄₂ " ) or 16 mm

( ⁵⁄₈ " ) hose.

Only for 13 mm ( ¹⁄₂ " ) hose :

The universal fitting

Regulator Valve Art. No. 977 so that the contents of the out-

let line do not flow back through the pump after pumping. The

Regulator Valve can be ordered from your GARDENA dealer.

The float switch

water level exceeds the cut-in height and the water is pumped out.

The float switch

level falls below the cut-out height.

1. Stand the pump on a firm surface

– or –

use a rope attached through the bore hole in the carrying

handle

to immerse the pump in a well or shaft.

During automatic operation, ensure that the float switch

can move freely.

2. Plug the power cable

Adjusting the Cut-in and Cut-out Height :

The maximum cut-in height and minimum cut-out height (see

8. Technical Data) can be adjusted.

v Press the cable of the float switch

switch lock

Do not select a cable length that is too long or short to ensure

that the float switch can turn on and off properly.

• The higher the opening of the float switch lock

the cut-in and cut-out height.

• The shorter the length of cable between the float switch

and the float switch lock

higher the cut-out height.

The cable length between the float switch

lock

must always be at least 10 cm.

allows you to connect all the hoses listed

onto the pump.

can also be equipped with a GARDENA

turns the pump on automatically when the

turns the pump off again as soon as the water

into a mains socket.

, the lower the cut-in height and the

, which are not needed,

into an opening in the float

, the higher

and the float switch