Gardena FP 1000 Інструкція з експлуатації Посібник з експлуатації - Сторінка 3
Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Водяний насос Gardena FP 1000. Gardena FP 1000 11 сторінок. Fountain pump set
Також для Gardena FP 1000: Інструкція з експлуатації Посібник з експлуатації (12 сторінок), Інструкція з експлуатації Посібник з експлуатації (12 сторінок)
Друкувати сторінку
Data indicated on the type plate must match
technical data of the mains supply.
Please unplug the pump after operation and
before carrying out any maintenance works.
The pump must not be operated when there
are people in the water.
Swimming pools and garden ponds should
be designed according to international and
national design regulations.
v Please consult a professional electrician.
Before operating the pump, look to see if there
is any damage to the pump (esp. regarding
power cable and plug).
The connection cable of the pump cannot be
replaced. If the cable is damaged the pump
must be scrapped.
Do not use the power cable to carry the pump
or to pull the plug out of the socket.
Protect the power cable from heat, oil and
sharp edges.
3. Assembly
A
Installing the set as a
fountain pump :
4
a
b
7
1
10
The stepped nipple (½ " / ¾ " )
example, to a gargoyle.
1. Screw the T-piece
2. Screw the stepped nipple
7
T-piece
.
3
3. Screw the ball joint
4. Push the nozzle tube
a
the sleeve
5. Snap the nozzle tube
6. Screw required fountain insert
nozzle tube
2
6
a) Cascade
For Austria :
Pumps for use on swimming pools and on
ponds may only be operated via an isolating
transformer.
v Please consult a professional electrician.
For Switzerland :
In Switzerland mobile appliances which are
used outdoors, must be connected via a
residual-current device.
Directions for use :
Do not allow the pump to run without
water because dry-running leads to an
undesirable build up of heat and will
destroy the pump.
The temperature of the liquid used must not
be below 4 °C or above 35 °C.
Sand and other abrasive substances in the
liquid cause increased wear and reduce the
output of the pump.
Please observe the local noise prevention
regulations.
6
can be used for connection, for
7
onto the adapter
6
onto the side outlet of the
2
onto the T-piece
3
onto the telescopic handle
.
3
into the ball joint
4
a) / b) / c) / d) fully into the
3
.
b) Water Bell
c) Fleur-de-Lis
1
.
7
.
b
up to
2
.
d) Water Jets