Gardena GP 3000/4 Посібник оператора - Сторінка 6
Переглянути онлайн або завантажити pdf Посібник оператора для Водяний насос Gardena GP 3000/4. Gardena GP 3000/4 10 сторінок. Garden pump
Також для Gardena GP 3000/4: Посібник оператора (10 сторінок), Посібник оператора (11 сторінок)
IMPORTANT!
v Dispose of the product through or via your municipal recycling
collection centre.
6. TROUBLESHOOTING
DANGER! Risk of injury!
Injury when the product starts accidentally.
v Disconnect the product from the mains before you trouble-
shoot the product.
To loosen the impeller [ Fig. T1 ]:
An impeller blocked by dirt can be freed again.
(10)
v Turn shaft of the impeller
with a screwdriver.
This will loosen the stuck impeller.
Problem
Possible Cause
Pump is running, but the
Leaky or damaged suction
suction action doesn't take
hose.
place
The pump was not filled with
water.
The liquid escapes over the
hose which is connected to
the delivery side during the
suction action.
Absolutely vacuum-resistant connection is achieved by using
GARDENA Suction Hoses (see 8. ACCESSORIES).
Leaky screw fitting at the filler
neck.
Air cannot escape, since
delivery side is closed or
remaining water is in the
pressure hose.
The waiting time wasn't
observed.
Suction filter or backflow
preventer in the suction hose
clogged.
Too high suction height.
In case of any other difficulties concerning the suction action,
use GARDENA Suction Hoses with Backflow Preventer
(see 8. ACCESSORIES) and fill in the liquid to be pumped
over the filler neck before operation.
Pump does not start,
Thermal switch has turned
or stops suddenly during
the pump off because of over-
operation
heating.
No power supply to the pump.
RCD has triggered
(residual current).
Pump is not switched on.
Pump is running but the
Suction hose end is not
delivery drops suddenly
in water.
Suction filter or backflow
preventer clogged.
Leaks at suction side.
Impeller blocked.
Noise development in the
In the case of strong flows (e.g. open hose end, without connec-
hydraulic area
ting device), noise may result in the hydraulic part of the pump.
This is harmless and does not lead to damage of the pump.
The noise can be removed by lightly changing the flow (e. g. light
opening / closing of a connecting device).
NOTE: For any other malfunctions please contact the GARDENA service
department. Repairs must only be done by GARDENA service departments
or specialist dealers approved by GARDENA.
6
7. TECHNICAL DATA
Garden Pump
Rated power
Mains voltage
Mains frequency
Max. delivery capacity
Max. pressure /
max. delivery head
Max. self-priming suction
height
Permitted internal pressure
(delivery side)
Power cable
Weight
Sound power level L
Remedy
measured / guaranteed
Uncertainty k
v Check suction line for
damage and seal so is
Max. media temperature
airtight.
Measuring process complying with:
v Fill the pump
(see 3. OPERATION).
v 1. Fill the pump again
8. ACCESSORIES
(see 3. OPERATION).
2. When starting operation
hold the pressure hose
approx. 1 m vertically
GARDENA Suction Hoses
above the pump, until the
suction action has taken
place.
GARDENA Suction Hose
Fitting
v Check seal (replace if neces-
GARDENA Pump
sary) and tighten connection
Connection Set
securely (do not use pliers).
GARDENA Suction Filter
v Open shut-off valves
with backflow preventer
(e g. nozzle) in the delivery
GARDENA Pump
line, empty the delivery hose
Preliminary-Filter
or disconnect it from the
pump during priming.
GARDENA Electronic
Manometric Switch
v Switch on the pump and wait
up to 5 min.
GARDENA Bore Hole
v Clean the filter or the back
Suction Hose
flow preventer.
GARDENA Floating suction
v Reduce suction height.
system
GARDENA Pump
Connection Piece
v Observe the max. media
temperature (35 °C).
9. SERVICE / WARRANTY
v Check fuses and electrical
Service:
plug connections.
Please contact the address on the back page.
v Disconnect the pump
and contact the GARDENA
Warranty statement:
Service.
In the event of a warranty claim, no charge is levied to you for the
v Push the On / Off switch
services provided.
to On.
GARDENA Manufacturing GmbH grants a warranty for all original
v Submerge the end of the suc-
GARDENA new products for two years from the date of original purchase
tion hose deeper in the water.
from the retailer, provided that the devices have been for private use only.
This manufacturer's warranty does not apply to products acquired second
v Clean the suction filter or
hand. This warranty includes all significant defects of the product that can
back-flow preventer.
be proved to be material or manufacturing faults. This war ranty is fulfilled
v Eliminate leak.
by supplying a fully functional replacement product or by repairing the
faulty product sent to us free of charge; we reserve the right to choose
v Release impeller.
between these options. This service is subject to the following provisions:
• The product has been used for its intended purpose as per the
recommendations in the operating instructions.
• Neither the purchaser nor a third party has attempted to open or
repair the product.
• Only Original GARDENA replacement parts and wear parts have been
used for operation.
• Presentation of the receipt.
Unit
Value
(Art. 9010)
W
600
V (AC)
230
Hz
50
l/h
3000
bar /
3.5 /
m
35
m
7
bar
6
m
1.5 (H07RN-F)
kg
5.3
1)
WA
77 / 80
dB(A)
3
2)
WA
°C
35
RL 2000/14/EU
1)
2)
Kink-proof and vacuum-proof, optionally available by the metre
Art. 1720 / 1721 (19 mm (3/4")- / 25 mm (1")) without connecting
fittings or in fixed length Art. 1411 / 1418 complete with connecting
fittings.
For connection on the suction side.
For connection on the delivery side.
To equip suction hoses with backflow
preventer sold by the metre.
Recommended for pumping sandy liquids.
Automatically cuts in and out the pump
depending on the current operating pressure.
With dry-running safety.
For vacuum-resistant connection of the pump
to boreholes or pipe networks. Length 0.5 m.
With 33.3 mm (G1) female thread at both ends.
For dirt-free suction below the water surface.
For connecting the GARDENA Connection
System on the pressure side.
Value
(Art. 9013)
800
230
50
3600
4.0 /
40
7
6
1.5 (H07RN-F)
8.2
71 / 73
2.2
35
ISO 4871
Art. 1723 / 1724
Art. 1750 / 1752
Art.
1726 / 1727 / 1728
Art. 1730 / 1731
Art. 1739
Art. 1729
Art. 1417
Art. 1745