Corvus systems TRS-80 II Посібник з монтажу - Сторінка 10

Переглянути онлайн або завантажити pdf Посібник з монтажу для Робочий стіл Corvus systems TRS-80 II. Corvus systems TRS-80 II 19 сторінок. Corvus systems disk system installation guide

Друкувати сторінку

The AC power cord connector and fuse are found at the

bottom right of the back panel on all drive models.

To change the voltage selection, flip the small circuit board

and install the proper fuse as follows:

Voltage Selection and Fuses

Slide open the clear plastic cover door, pull the fuse-pull

lever to the left, and remove the fuse.

Use long-nose pliers to carefully pull the voltage circuit

board out of the fuse housing. To select the proper

operating voltage, position the circuit board so that the

desired voltage displays on the top left side of the board.

Push the board firmly into the slot.

Do not re-insert the fuse you removed if you have chosen

a different voltage setting from the one you received with

the drive. Select the correct slow blow fuse using the

following table:

Disk Drives:

100 or 120 volt 2.0 amp

220 or 240 volt 1.0 amp

To return the fuse to its receptacle, push the fuse-pull lever

to the right and insert a fuse into the holder. Slide the clear

plastic cover door to the right to expose the AC power

cord

connector.