Gardena EasyCut 9823 Інструкція з експлуатації Посібник з експлуатації - Сторінка 9
Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Тример Gardena EasyCut 9823. Gardena EasyCut 9823 16 сторінок. Accu turbotrimmer
Також для Gardena EasyCut 9823: Інструкція з експлуатації Посібник з експлуатації (18 сторінок), Інструкція з експлуатації Посібник з експлуатації (17 сторінок)
Друкувати сторінку
8. Troubleshooting
DANGER!
Risk of cutting
injuries!
Replacing the plastic blade:
s
B
Problem
The Trimmer is not cutting
cleanly or not cutting at all
The trimmer vibrates severely
The trimmer does not start
The trimmer stops.
Error-LED
flashes
ß
W
Charging indicator lamp
the charger does not light up
Charging control lamp
on the charger flashes rapidly
(twice per second)
Risk of injury from blade!
v R emove the battery immediately in the event of faults!
DANGER! Risk of cutting injuries!
v N ever use metal cutting elements or spare parts
A
The blades may only become worn to half the original length
at most. Only use original GARDENA Spare Blades.
Spare blades are available from your GARDENA dealer or
direct from GARDENA Service.
• GARDENA Spare Blades for Turbotrimmer
Disassembling the plastic blade:
1. Turn the trimmer over.
e
2. Press end of blade down slightly (A), slide blade
through blade carrier
Assembling the plastic blade:
v S lide new blade
carrier
s
When the new blade is correctly inserted, it can be moved more
easily.
Possible Cause
Blade worn or too short.
Blade broken off.
The blade is excessively worn
and creates an unbalance.
Battery is flat.
Battery not pushed onto the
handle properly.
Motor blockage.
Battery overload.
High temperature. The allowed
operation temperature was
exceded.
on
Battery charger or charging
9
cable not plugged in properly.
Charging error.
9
and accessories not intended for use by GARDENA.
(B) and pull out.
s
from inside through slot in metal of blade
e
until it snaps into place.
Art. No. 5368
inside
e
Remedy
v R eplace blade.
v R eplace blade.
v R eplace blade.
v Charge battery
(see 4. Initial Operation).
v Push battery onto the handle
and make sure that the lock-
ing buttons snap in correctly.
v Unblock and restart the
device.
v Wait for 10 sec. Press button
on the battery and restart.
ß
B
v Leave battery to cool for
approx. 15 min. Press button
on the battery and restart.
ß
B
v Plug in battery charger and
charging cable properly.
v Unplug charger and plug
in again.
19