Makita 6010DWK Інструкція з експлуатації - Сторінка 4
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Дриль. Makita 6010DWK. Makita 6010DWK 14 сторінок. 10 mm (3/8")
Також для Makita 6010DWK: Інструкція з експлуатації (9 сторінок), Інструкція з експлуатації (17 сторінок)
IMPORTANT SAFETY INSTRUCTIONS
Length of Cord (Feet)
AWG Size of Cord
I.
SAVE THESE INSTRUCTIONS
- This manual
25
50
100
150
18
1 8
18
1 6
contains important safety and operating instructions for battery charger.
2.
Before using battery charger, read all instructions and cautionary markings
on
(1)
battery charger,
(2)
battery, and
(3)
product using battery.
3.
CAUTION - To reduce risk of injury, charge only MAKITA Battery
7000.
Other types of batteries may burst causing personal injury and damage.
4. Do not expose charger t o rain or snow.
5.
Use of an attachment not recommended or sold by the battery charger
manufacturer may result in a risk of fire, electric shock, or injury t o persons.
6.
To reduce risk of damage t o electric plug and cord, pull by plug rather than
cord when disconnecting charger.
7.
Make sure cord is located so that it will not be stepped on, tripped over, or
otherwise subjected t o damage or stress.
8.
A n extension cord should not be used unless absolutely necessary. Use of
improper extension cord could result in a risk of fire and electric shock. If
extension cord must be used, make sure:
a. That pins
on
plug of extension cord are the same number, size, and shape
b. That extension cord is properly wired and in good electrical condition; and
c. That wire size is at least as large as the one specified in the table below.
TABLE
1
RECOMMENDED MINIMUM AWG SIZE FOR
EXTENSION CORDS
FOR
BATTERY CHARGERS
as those of plug on charger;
9.
Do not operate charger w i t h damaged cord or plug - replace them im-
mediately.
IO.
Do not operate charger
if
it has received a sharp blow, been dropped, or other-
wise damaged in any way; take it t o a qualified serviceman.
11.
Do not disassemble charger or battery cartridge; take it t o a qualified
serviceman when service or repair is required. Incorrect reassembly may
result in a risk of electric shock or fire.
12.
To reduce risk of electric shock, unplug charger from outlet before attempt-
ing any maintenance or cleaning. Turning off controls will not reduce this risk.
4