Makita 6016D Технічна інформація - Сторінка 4
Переглянути онлайн або завантажити pdf Технічна інформація для Дриль. Makita 6016D. Makita 6016D 5 сторінок. 10mm cordless drills
Друкувати сторінку(2) Cautions in assembling
(a) Assembling of motor and gear assembly
*Since the motor bracket is mounted on the gear assembly for
repair, turn counterclockwise(viewed from motor bracket
side) the motor bracket beforehand to disconnect it from the
gear assembly.
1) Screw the motor bracket into the motor.
2) Turn clockwise(viewed from motor bracket side) the motor
assembling parts(shown in 1)to mount them on the gear
assembly. At this time assemble in a way that the red mark
on the motor edge is placed on the change lever side of the
gear assembly.
(b) Mounting of speed change lever
1) Mount the compression spring 4 on the speed change lever.
2) Mount the speed change lever on the protrusion of the change lever as shown on the figure 3 while using
care so that the compression spring 4 may not be jumped out.
(c) Assembling on the housing
1) To assemble the one body of gear assembly and motor etc. on the housing L, place the speed change lever
at the position as shown on the figure 4.
2)
Use care that the compression spring 4 may not be jumped out in assembling on the housing.
(d) Assembling of drill chuck
1)
Fasten the chuck into the spindle and body face .
2)
Mount the hexagon rod on the chuck and use the vice to fix the hexagon rod.
3)
Set to the normal rotation and low speed. Use the full charged battery.
4)
Insert the switch and fasten the chuck while securely holding the handle.
*Weakly holding the handle may let you turned around when motor locking.
5)
Widen the claw of chuck at maximum and fasten the pan head screw for holding the chuck.
*The left hand thread is used for pan head screw.
Compression spring 4
Inner side of
housing L
Figure 4
Gear assembly
Motor bracket
Protrusion of the change lever
Speed
Motor
change
lever
The speed change lever should
be positioned at either side
Turning direction in assembling
Figure 2
Gear assembly
Figure 3
Red mark