Makita 6093D Інструкція з експлуатації - Сторінка 3
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Дриль. Makita 6093D. Makita 6093D 16 сторінок. Equipped with electric brake 10 mm (3/8") with fast charger
Також для Makita 6093D: Інструкція з експлуатації (17 сторінок)
Друкувати сторінку
14. REMOVE A DJUSTING KEYS ANDWRENCHES. Formhabitof checking to
seethatkeys andadjusting wrenches areremoved f romtoolbefore turning
it on.
15. AVOID UNINTENTIONAL
STARTING. Don'tcarryplugged-in t oolwith
finger
on switch.
Be sure switch
is OFF when
plugging in.
16. OUTDOOR
USE EXTENSION
CORDS. When tool is used outdoors,
usa only
extension
cords intended
for use outdoors
and so marked.
17. STAY ALERT. Watch what you are doing, use common sense. Don't operate
tool when
you are tired.
18. CHECK
DAMAGED
PARTS, Before further use of the tool, a guard or other
part that is damaged
should be carefully
checked to determine
that it will
operate
properly and perform its intended
function.
Check for alignment
of
moving parts, binding of moving parts, breakage of parts, mounting, and any
other conditions
that may affect
its operation.
A guard or other part that
is damaged
should be properly repaired
or replaced
by an authorized
serv-
ice center unless otherwise
indicated
elsewhere
in this instruction
manual.
Have defective
switches
replaced
by authorized
service center.
Don't use
tool if switch
does not turn it on and off.
19. GUARD
AGAINST
ELECTRIC SHOCK.
Prevent body contact
with grounded
surfaces.
For example;
pipes,
radiators,
ranges,
refrigerator
enclosures.
20. REPLACEMENT
PARTS. When servicing, use only identical replacement
parts.
VOLTAGE WARNING:
Before connecting
the tool to a power source (receptacle,
outlet,
etc.) be sure the voltage
supplied is the same as that specified
on the
nameplate
of the tool. A power source with voltage greater than that specified
for the tool can result in SERIOUS
INJURY to the user -
as well as damage
to
the tool. If in doubt,
DO NOT PLUG IN THE TOOL. Using a power source with
voltage
less than the nameplate
rating is harmful
to the motor.