Makita 6096D Посібник користувача - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник користувача для Дриль. Makita 6096D. Makita 6096D 5 сторінок. Cordless high speed drill equipped with electric brake
Також для Makita 6096D: Інструкція з експлуатації (9 сторінок), Інструкція з експлуатації (17 сторінок), Інструкція з експлуатації (13 сторінок)

epair

(1) Cautions in Disassembling

To replace the gear assembly, firstly disconnect the drill chuck. (If the housing only is disassembled, its no need to

disconnect the chuck.) Use care not to miss the compression spring 4 inside the speed change lever since it can

be easily jumped out when disassembling.

(2) Cautions in assembling

1.Assembling of the motor and gear assembly

*As the motor bracket is mounted on the gear assembly for

repair, turn the motor bracket counterclockwise (viewed from

the motor bracket side) to remove it from the gear assembly.

1) Assemble the motor bracket and the motor with screw.

Turn the motor assembling parts shown in 1) in clockwise (viewed from the motor bracket side) to

assemble them on the gear assembly. Make fit the red mark on the motor edge with the flat face of the

gear assembly.

2.Assembling of the leaf spring

Assemble the leaf spring on the housing L as shown on the

figure 3.

3.Assembling of the speed change lever

Set the two pieces of compression spring 4 in the speed change lever.

Assemble the speed change lever assembly on the protrusion of the change lever as shown on the figure 4

while using care that the compression spring 4 may not jump over.

change lever

compression spring 4

Flat face

Gear assembly

Motor bracket

Fig. 2

Housing "L" inside

change lever

assembly

Fig. 4

Motor

Protrution of the change lever

change lever

compression spring

Fig. 1

Red mark

Rotating direction arrow mark

Leaf spring

Fig. 3

Gear assembly