HIKVISION 8 Series Посібник користувача - Сторінка 9

Переглянути онлайн або завантажити pdf Посібник користувача для Домофонна система HIKVISION 8 Series. HIKVISION 8 Series 18 сторінок.

Chapter 2 Installation Preparation

Similar to other electronic products, the semiconductor chip easily gets damaged if

you power on and off abruptly and frequently. To restart up the switch of 4/8 switch, you

have to open the power on-off three or five seconds after the power is cut off.

Avoid severe collision or falling down from the height to protect the parts in the

switch.

Use correct outside ports to connect the switch of 4/8 switch. Do not insert the

Ethernet plug into the console port (RJ45 8-line socket). Similarly, do not insert the

console cable into the console port (RJ45 8-line socket).

Note:

1) When you plug or dial out the power line, keep the power line horizontal with the

power socket.

2) When the lifetime of our products ends, handle them according to national laws and

regulations, or send these products to our company for collective processing.

 Keep dustless and clean during or after the installation.

 Put the cover at the safe place.

 Put tools at the right place where they are not easily falling down.

 Put on relatively tight clothes, fasten the tie or scarf well and roll up the sleeve,

avoiding stumbling the chassis.

 Put on the protective glasses if the environment may cause damage to your

eyes.

 Avoid incorrect operations that may cause damage to human or devices.

The safety notices mentioned here means that improper operation may lead to body

damage.

 Read the installation guide carefully before you operate the system.

 Only professionals are allowed to install or replace the switch.

 Please cut off the direct-current connection when you operate the hull or work

near the power supply.

 The final configuration of products must comply with relative national laws and

regulations.

When you work under electricity, following the following principles:

- 4 -