Gardena 869 Інструкція з експлуатації - Сторінка 3

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Фарборозпилювач Gardena 869. Gardena 869 3 сторінки. 3 l and 5 l
Також для Gardena 869: Інструкція з експлуатації Посібник з експлуатації (9 сторінок)

Друкувати сторінку

GARDENA Pressure Sprayer 3 l / 5 l

Translation of the original German operating instructions.

Please read the operating instructions carefully and observe the notes

given. Use the instructions to familiarise yourself with the Pressure

Sprayer, its proper use and the notes on safety. For safety reasons,

children under 16 as well as persons not familiar with these operating

instructions must not use the Pressure Sprayer. Never operate the

product when you are tired, ill or under the influence of alcohol, drugs

or medicine.

Keep these operating instructions in a safe place.

1. Area of application of your GARDENA Pressure Sprayer

Intended purpose:

The GARDENA Pressure Sprayer is intended for distributing solvent-free

liquid pesticides

, herbicides

, fertilisers

wax

in domestic gardens and allotments. It must not be used in public

places, parks, sport arenas, or in agriculture or forestry.

Compliance with the operating instructions provided by the manu-

facturer is a prerequisite for using the Pressure Sprayer correctly.

In accordance with the laws governing the use of pesticides and detergents, only authorised

substances may be used (authorised specialist shop).

Please note:

Due of the risk of physical injury, the GARDENA Pressure Sprayer

must not be used for spraying substances other than those specified

by GARDENA.

Also, no acids, disinfectants or impregnators, aggressive and solvent-

containing cleaning agents, petrol or spray oil may be sprayed.

We recommend that you only use pesticides approved by the BBA

(German Federal Biological Research Centre for Agriculture and

Forestry). To our knowledge at the time of manufacturing the unit, the

pesticides approved by the BBA will not damage the materials used to

construct the Pressure Sprayer.

When spraying insecticides, herbicides and fungicides or other liquid

plant protection products, you must comply with all special pre-

cautionary measures specified by the manufacturer of the product you

are using.

2. Safety instructions

Danger of physical injuries:

Never open the Pressure Sprayer or unscrew the nozzle when the

Pressure Sprayer is still pressurised. To prevent injury, never connect

the Pressure Sprayer to an air-compressor. Before pulling out the

safety valve

(Fig. A3), the sprayer always has to be placed vertically.

Before opening the sprayer, always release pressure completely by

pulling out the safety valve.

Danger! Small parts could be swallowed during assembly and there

is a risk of suffocation from the polybag. Keep infants away during

assembly.

Operation:

Inspect the Pressure Sprayer visually before each use. Never leave your

Pressure Sprayer unattended or for long periods when full and pres-

surised. Keep the unit out of the reach of children. You are responsible

for the safety of others. Keep your Pressure Sprayer away from heat

sources and hot environments. Screw tank cap

use any tools) and check the correct fit of the O-ring

Cleaning:

Release the pressure after each use, empty the container, clean it

carefully, rinse it with clear water and clean the sieve

the pressure sprayer open and allow it to dry. Do not dispose of residual

fluids in the sewerage system (local disposal systems). Always clean

the Pressure Sprayer before using a different product to avoid chemical

reactions. If more than one Pressure Sprayer is used, tanks and tank

caps must not be interchanged.

Storage:

Before storing, loosen the tank cap and always empty your Pressure

Sprayer completely (also after cleaning with water). Store away from

frost. If you use the permanent lock

work very carefully. Never store your pressure sprayer with permanent

lock.

3. Assembly

A1 Mounting the spray tube

A2 Attaching the spray hose

A3 Attaching the spray hose

A4 Assemble shoulder straps

A5 Install suction hose

with sieve

4. Operation

Please observe the safety and proportioning instructions provided by the

manufacturer of the product you are going to spray.

B1 Unscrew tank cap

and fill tank

WARNING!: The tank may be filled with a maximum of 3 l

(Art. 867) / 5 l (Art. 869) of liquid.

, window cleaners

, and car

tight by hand (do not

(Fig. B1).

. Then leave

(Fig. B3) pay attention that you

in the hand valve

to the hand valve

to the container cap

A3 Pump using the handle

B2 Set mist spray via the nozzle

B3 Press operating tab

and spray liquid.

5. Cleaning

Cleaning the Pressure Sprayer:

Always clean your Pressure Sprayer after spraying.

Use Pressure Sprayer only with clear water (possibly with addition of

dish detergent) and spray empty. The valves, the suction hose

the spray pipe

, the nozzle

case of outer dirtying of handle and tank, thoroughly clean the area

thread and thread O-ring

. We recommend that you have your

Pressure Sprayer thoroughly inspected (preferably at a GARDENA

Service Centre) after using it for 5 years.

6. Trouble-Shooting

C1 Cleaning the sieve:

v Open up sieve

on suction hose

Problem

Possible Cause

Pump does not

Safety valve

build up pressure.

loose.

Hose connection at

the container and

hand valve is not tight.

Continuous lock

enabled on handle.

Sealing cap

defective.

Pressure Sprayer

Nozzle

does not spray

although there is

Sieve

sufficient pressure

hose clogged.

or only sprays with

a weak spray jet.

It is difficult to

Container pressure

open and close the

too high.

container.

If you have any other problems with your Pressure Sprayer please

contact GARDENA Customer Service.

7. Putting into Storage

Storing your Pressure Sprayer:

1. Clean the Pressure Sprayer (refer to 5. Cleaning).

2. Keep your Pressure Sprayer in a place protected from frost.

8. Available accessories

GARDENA Weedkiller Cone

GARDENA Extension Lance

9. Technical data

Max. capacity

Spray tube length

Hose length

Permissible working pressure

Max. permissible operating

temperature

10. Warranty

GARDENA Manufacturing GmbH guarantees this unit for 2 years (from

date of purchase). This guarantee covers all serious defects of the unit

that can be proved to be material or manufacturing faults. Under war-

ranty we will either replace the unit or repair it free of charge if the fol-

lowing conditions apply: The unit must have been handled properly and

in keeping with the requirements of the operating instructions. Neither

the purchaser or a non- authorised third party have attempted to repair

the unit. This manufacturer's guarantee does not affect the user's exist-

ing warranty claims against the dealer / seller.

If you have problems with this unit, please contact our Service.

and the sieve

are cleaned. In the

and clean it.

Remedy

Tighten the safety

valve

Tighten the hose con-

nections at the con-

tainer and hand valve.

Release lock

handle.

dirty /

Clean or exchange

sealing cap

is blocked.

Unscrew nozzle

and clean.

on suction

Open up sieve

clean it.

Release the container

pressure completely

by means of the safety

valve

Prevents spray mist from

blowing away.

Art. No. 894

For extending the spray

tube.

Art. No. 897

Art. 867 (3 l)

Art. 869 (5 l)

3 l

5 l

36 cm

175 cm

3 bar

40 °C

and