Makita 6281D Технічна інформація - Сторінка 4

Переглянути онлайн або завантажити pdf Технічна інформація для Дриль. Makita 6281D. Makita 6281D 7 сторінок. 14.4v
Також для Makita 6281D: Інструкція з експлуатації (8 сторінок)

Друкувати сторінку

epair

[3] DISASSEMBLY/ASSEMBLY

[3]-2. Gear Assembly, DC Motor

ASSEMBLING

The following portions of DC motor, Motor bracket and Gear ass'y have to face the same side. (Fig. 8)

* Red point mark (designated as plus terminal) on DC Motor

* None of protrusion side of Motor bracket

* Gear assembly's protrusion

Fig. 8

protrusion of Gear ass'y

Gear ass'y

Do not face the protrusion of

Motor bracket to the protrusion

of Gear ass'y and the red

point mark on DC motor.

[3]-3. Speed Change Lever

ASSEMBLY

(1) When assembling Speed change lever ass'y, make sure two Compression springs are assembled to its bottom

in advance. (Fig. 9)

(2) Fit the protrusion of Gear ass'y into Compression spring 4 in Speed change lever ass'y . (Fig. 10)

(3) After mounting, set Speed change lever ass'y to low speed mode or high speed mode. (Fig. 11)

Fig. 9

Compression

spring 4 (2 pcs.)

Speed change lever

ass'y

Fig. 11

1: Low speed mode

Speed change

lever ass'y

none of protrusion

side

Motor bracket

DC motor

Fig. 10

protrusion of Gear ass'y

2: High speed mode

Slide Speed change lever to either of

the direction designated in arrow, and hold

the position.

red point mark

on DC motor

P 4/ 7