Alien Aircraft Corp AE-502 Посібник із швидкого старту - Сторінка 5
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Іграшка Alien Aircraft Corp AE-502. Alien Aircraft Corp AE-502 6 сторінок. Electric conversion
Друкувати сторінкуTHEN
...Cut out the hatch on the dashed line.
...Glue the E-05's and E-06's to the inside of E-01 to make a
frame / ledge for the hatch to sit on.
NOTE: We do not include any latch for the hatch because I
have found that everyone seems to secure the hatch differently
than I do, and I don't like to sell you parts that you will not use.
I held the hatch in place with a tongue in the front and two #2
sheet metal screws in the rear corners. You can use this method,
magnets, wire clips, or what ever method you prefer.
Now follow steps 51 through 151 to build the wing, struts, cover, and the beginning of the final assembly.
Follow the remainder of the final assembly steps in the main manual with the following exceptions:
Step 182, 183 and 184 are not required. Instead, mount your motor on the firewall.
...Mount the electronic speed control.
Step 196...This step is not required.
...WITH THE PROPELLER REMOVED...Turn the transmitter on. Place the throttle stick in the low position. Plug
the battery into the speed controller. Check the motor for proper operation and direction of rotation. Follow the
instructions with the speed controller to make any adjustments.
265...Check the servos for proper operation and direction. Adjust the control throws to the values shown on the plan.
Now disconnect the battery and then turn off the transmitter.
266...Install the propeller Place the battery in the nose of the model and install the hatch.
267...Check the balance of the model. It should balance at the position shown on the plan. Move the battery forward
or aft to achieve the proper balance. Use the velcro straps to secure the battery in the model in this position. Mark
the location of the battery on the fuselage side. This will allow you to quickly reinstall the battery at the location that
gives the proper balance. Note: If moving the battery will not achieve the proper balance, you will have to add
weight to the nose or tail. Glue any weight securely to the model.
268...Your model is now ready to fly. Fully charge the transmitter and airborne battery before attempting to fly the
model. Always range check and do a thorough pre-flight of the model before every flight. Always follow estab-
lished safety guidelines while operating the motor, radio and flying your model.
Page 5