ALIGNER CCD2.0WIFI Встановлення та інструкція - Сторінка 6
Переглянути онлайн або завантажити pdf Встановлення та інструкція для Випробувальне обладнання ALIGNER CCD2.0WIFI. ALIGNER CCD2.0WIFI 16 сторінок.
Друкувати сторінку
3 ASSOCIATION OF DETECTORS TO THE SERVICE PC
To perform the configuration and calibration of the CCD2.0WiFi detectors, a PC (*) must be used if
necessary, with the service SW installed
The CCD20Config service SW can be downloaded from the manufacturer's support site.
(*) A PC with S.O. is required Win7 or Win10 with common 802.11b/g/n WLAN Wireless Network card
Firstly connect the service PC to the "connect" Wi‐Fi network of the CCD2.0WiFi system, which is generated
by the Access Point supplied with the equipment, to which the front detectors and the Tablet are also
connected.
the Tablet must
not be used
On power‐up the detectors
automatically connect to the
"
After the PC and the detectors have been switched on and connected to the "connect" network, it is
necessary to "associate" the detectors with the service PC, following the procedure described below.
Press F2 from the home page, the Figure 7 page appears, then select "WIFI search"
Page 4/14
"
.
Figure 5
Access Point Wifi SSID = connect
Password = 123connect
Figure 6
Figure 7
R0368
Cod. R0368 ‐ rev.1.0
(03/2020)