AEG 30" B3007H-L-B Посібник користувача - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник користувача для Духовка. AEG 30" B3007H-L-B. AEG 30" B3007H-L-B 34 сторінки. 30” built-in oven

B-

Using the appliance for the first time

After installation remove all notification labels (not identification or warning labels) and packaging

materials. After cleaning make sure cleaned surfaces are thoroughly rinsed and wiped dry using a

clean, soft cloth.

NOTE: oven will not operate unless time clock is set

The clock will require setting when you first turn on the power (or following a power failure).

At the power on the timer shows the clock flashing and is increased by one unit every minute.

The oven does not work and need to adjust the time.

Burning in

Before cooking in the appliance an initial pre-heating is required to burn off the fine oil film used to

protect the elements for shipping. The first time you heat up the oven (or grill) the oil will be given

off as smoke, which is perfectly normal.

Select a cooking mode and set the oven temperature to 180°C. With the oven door closed, leave

for approximately 5 minutes.

Repeat the above step for each cooking mode.

After completing the above make sure all controls are turned off. The oven is now ready for

cooking and grilling.

NOTE:

On oven start up or possibly at other times, due to electricity supply deviations – the

programmer may freeze on a function – if this occurs we recommend that, after checking

other solutions without success, it is recommended that power supply be disconnected to

the appliance and allow it to be in this position for some minutes before reconnecting.

This may have a result of clearing the frozen position allowing you to reset the

programmer for normal operation.

Cooling Fan

The Ovens are provided with a cooling fan motor to reduce the heat around the oven. The fan

motor is activated, independently from oven temperature, at the start of cooking program.

When you end the cooking program, a period of observation starts, during which the cooling fan

is kept on if the temperature is over 50°C

This safeguards both the oven and the adjoining cupboards from the possibility of temperature

damage.

Safety Thermostat

Your oven is fitted with an over temperature sensor that will automatically shut down your oven

for a period if it is deemed to be overheating- this sensor is fitted to the rear wall of the oven,

inside the outer case – it will only activate in extreme circumstances and is provided as protection

to the appliance and the adjoining furnishings. If activated it will shut down the appliance for a

short time and will automatically reset allowing normal operations – you should consult your

service technician if the problem re-occurs.