AEG 30" DEO76 Посібник користувача - Сторінка 28
Переглянути онлайн або завантажити pdf Посібник користувача для Духовка. AEG 30" DEO76. AEG 30" DEO76 33 сторінки. 30” built-in double oven
Також для AEG 30" DEO76: Посібник користувача (13 сторінок)
![AEG 30](/uploads/products/server2/223454/223454.png)
- 1. Table of Contents
- 2. A - Installation Check and Warnings
- 3. B - Accessories
- 4. C - Using the Appliance for the First Time
- 5. D - Electronic Programmer Operation
- 6. E - Cooking Modes and Instructions
- 7. F - Cleaning and Maintenance
- 8. G - Trouble Shooting Guide
- 9. H - Installation Instructions
- 10. I - Electrical Wiring Diagrams and Instructions
- 11. Warranty
I - Electrical wiring diagrams and instructions
WARNING:
All aspects of the installation must conform with the requirements of the standard North America
(within North America) wiring rules, as well as your local electrical and building codes and
regulations, and any other applicable requirements and conditions of your local power supply
authority.
A licensed electrician must perform the electrical work when installing this appliance. The supply
cable and fuse rating must be suitable for the appliance.
240 Volt 60hZ 30AMP single/40AMP double service
WARNING:
A licenced electrician must connect the armour cable and 3 wires into the electrical connection
box. The white, or Neutral wire is not used, and must be capped using a marette.
To avoid power borne interference, this appliance must be installed individually on a separate and
distinct final sub-circuit.
Note:
To the electrician – please ensure sufficient supply cable is provided to allow the appliance to be
removed from the cavity should any servicing be necessary. This will also allow easy connection of the
supply.
Voltage supply connection
To connect the electrical supply:
1- Ensure the supply cable and fuse rating are suitable for the appliance (see the electrical
loading).
2- Remove the cover plate by undoing the screw.
3- Fit a suitable entry bush to the conduit entry on the rear left of the appliance (with the rear
toward you) and feed the fixed wiring through.
4- Connect the wiring to the terminal block using the screw connections provided. Ensure the wires
are properly secured to prevent any high resistance electrical connection.
5- Replace the cover plate making certain that the supply wiring is clear of any metal work and the
screws.
When connected to a sub circuit, protected by a circuit breaker, it is recommended the circuit breaker be
the same as the total rating of the appliance.
Electrical Loads
Main Oven
Oven
Grill
Oven fan and light
Secondary Oven
Oven
Grill
Oven light and fan
Single Oven
2350 W
2800 W
100 W
Double Oven
2350 W
2800 W
150 W
2900 W
2000 W
100 W
28