AEG 6000 Series Посібник користувача - Сторінка 20
Переглянути онлайн або завантажити pdf Посібник користувача для Духовка. AEG 6000 Series. AEG 6000 Series 24 сторінки.
Також для AEG 6000 Series: Посібник користувача (12 сторінок), Посібник користувача (24 сторінок), Посібник користувача (24 сторінок)
Друкувати сторінку
20
www.aeg.com
Problem
The lamp does not work.
There is too much frost and
ice.
Water flows on the rear plate
of the refrigerator.
There is too much con‐
densed water on the rear
wall of the refrigerator.
Water flows inside the refrig‐
erator.
Water flows on the floor.
Possible cause
The lamp is in stand-by
mode.
The lamp is defective.
The door is not closed cor‐
rectly.
The gasket is deformed or
dirty.
Food products are not wrap‐
ped properly.
Temperature is set incorrect‐
ly.
Appliance is fully loaded and
is set to the lowest tempera‐
ture.
Temperature set in the appli‐
ance is too low and the am‐
bient temperature is too
high.
During the automatic de‐
frosting process, frost melts
on the rear plate.
Door was opened too fre‐
quently.
Door was not closed com‐
pletely.
Stored food was not wrap‐
ped.
Food products prevent the
water from flowing into the
water collector.
The water outlet is clogged.
The melting water outlet is
not connected to the evapo‐
rative tray above the com‐
pressor.
Solution
Close and open the door.
Contact the nearest Author‐
ized Service Centre.
Refer to "Closing the door"
section.
Refer to "Closing the door"
section.
Wrap the food products bet‐
ter.
Refer to "Control Panel"
chapter.
Set a higher temperature.
Refer to "Control Panel"
chapter.
Set a higher temperature.
Refer to "Control Panel"
chapter.
This is correct.
Open the door only when
necessary.
Make sure the door is closed
completely.
Wrap food in suitable pack‐
aging before storing it in the
appliance.
Make sure that food prod‐
ucts do not touch the rear
plate.
Clean the water outlet.
Attach the melting water out‐
let to the evaporative tray.