Alinco DR-135T MkII Короткий посібник - Сторінка 2

Переглянути онлайн або завантажити pdf Короткий посібник для Радіо Alinco DR-135T MkII. Alinco DR-135T MkII 3 сторінки.
Також для Alinco DR-135T MkII: Короткий посібник (2 сторінок)

Друкувати сторінку

Basic VFO Mode for Repeater Operation

Note that VFO Mode is the default mode upon power-up of the radio.

If the repeater that you desire is not pre-programmed into the radio, you may use the VFO Mode to tune to

the desired repeater. For Repeater operation, a few key pieces of information are required:

•

Repeater Output Frequency (e.g. 146.82)

•

Repeater Offset and Direction (e.g. –0.600MHz)

•

CTCSS or PL Tone (e.g. 103.5)

If you do not have this information – STOP -- and try to obtain the information. If you do have this

information, you may program the radio in VFO mode as follows:

1. Verify the radio is in VFO mode by checking that the memory mode M icon and Channel

Number are not visible on the left side of the display.

If the radio is in Memory Mode, press and release the V/M key (5) until the M and

Channel Number disappear from the display. It may take several presses of the key to

get into VFO mode.

2. Rotate the main Dial (3) clockwise to increase the frequency, counterclockwise to decrease the

frequency. Continue rotating the Dial (3) until you get to the desired repeater output frequency.

3. Set the Repeater Offset and Direction:

Press and release the Function key (4). You should see an F icon in the display.

b. Press and release the MHz/Shift key (6). The display will show the offset frequency and

direction; the default is –0.600MHz, as shown below:

Offset Direction

(Negative)

To change the offset direction (from negative "-" to positive "+"), press the MHz/Shift

key (6) until the display shows the correct offset direction.

i. Note the standard frequency offset for 2 Meter repeaters is 0.600MHz. You

d. Once the correct Offset Direction appears in the display, press and release the Squelch

key (9) to save the setting in VFO mode. The display will return to the frequency.

4. Set the Repeater CTCSS Tone:

Press and release the TS/DCS key (7) until only the T is displayed. The display will

show the current settings, as follows:

b. With the T icon on the display only, rotate the Dial (3) until the desired CTCSS Tone is

displayed (e.g. 103.5).

Once the correct Tone appears in the display, press and release the Squelch key (9) to

save the setting in VFO mode. The display will return to the frequency.

6. The transmit Power Level may be set to Low, Medium, or High as follows:

Press and release the FUNC key (4).

b. Press the Power Level/CALL key (8) to change the power level; each time you press the

Power Level/CALL key (8) a different setting will appear. Lo will appear in the display

for Low Power; Mi will appear for MID power; and no power indication icon will

indicate High power.

Press and release the FUNC key (4) to save the Power Level setting.

7. The radio is now programmed in VFO mode to use the desired repeater. To transmit press and

hold the Push to Talk button (11) on the Microphone (10). Release the Push to Talk button to

receive.

should not have to adjust the offset frequency, only the direction.

Offset

Frequency