Brother 885-X03 Посібник з експлуатації - Сторінка 26

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Швейна машина Brother 885-X03. Brother 885-X03 48 сторінок.
Також для Brother 885-X03: Посібник з експлуатації (48 сторінок), Посібник з експлуатації (48 сторінок)

Друкувати сторінку

SEWING BASICS — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —

■ Attaching the extra spool pin

Insert the extra spool pin onto the end of the bobbin

winder shaft. Install the second thread spool onto

the extra spool pin.

■ Twin needle threading

You should thread each needle separately.

Note

Models equipped with a needle threader

● You cannot use the needle threader to

thread the twin needle. Instead, thread the

twin needle by hand, from front to back.

Using the needle threader may damage the

machine.

Thread the left needle.

Follow the same instructions for threading a

single needle (see page 16).

Thread the right needle.

Thread the right needle in the same way that

you threaded the left needle using the thread

from the spool on the extra spool pin, but do not

pass the thread through the guide above the

needle before you pass it through the eye of the

right needle.

1 Left needle thread passes through the needle

bar thread guide

2 Right needle thread passes in front of the needle

bar thread guide

3 Needle bar thread guide

1 Bobbin winder shaft

2 Extra spool pin

3 Thread spool

Attach zigzag foot "J".

For details on changing the presser foot, refer

to "Changing the presser foot" on page 8.

CAUTION

●

When using the twin needle, be sure to

attach zigzag foot "J", otherwise the

needle may break or the machine may be

damaged.

Turn on the machine.

Select a stitch.

CAUTION

●

After selecting a stitch, slowly turn the

handwheel toward you

(counterclockwise) and check that the

needle does not touch the presser foot. If

the needle hits the presser foot, the

needle may bend or break.

●

The twin needle should only be used

with the Straight Stitch (Center Needle

Position), the Zigzag Stitch (1.5 mm

(1/16 inch)), the Triple Stretch Stitch

(Center Needle Position), and the Triple

Zigzag Stretch Stitch (1.5 mm

(1/16 inch)). Do not use the twin needle

with any other stitches.