Garmin GEA 71 Посібник з монтажу - Сторінка 27
Переглянути онлайн або завантажити pdf Посібник з монтажу для Дисплей авіоніки Garmin GEA 71. Garmin GEA 71 34 сторінки.
Друкувати сторінку
4.2
Electrical Characteristics
4.2.1
Analog Input Configuration
All analog inputs, except those discussed in Section 4.2.3 are multi-purpose capable and have several
configuration options. Table 4-1 summarizes the configuration options.
Configurable Parameter
Resistive Divider
Voltage Measurement Ranges
Bipolar/Unipolar
Constant Current Source
Miscellaneous Sensor
Configuration Parameters
If installing an ungrounded thermocouple to an Analog In input, a dc reference must be
added to the LO input. This can be accomplished by adding a resistance of 1 MΩ or less
between ground and the Analog In LO input that the ungrounded thermocouple is
installed on.
GEA 71 Installation Manual
190-00303-40
Table 4-1. Analog Input Configuration Summary
Resistive Divider can be enabled or disabled for each analog input.
Enabling & Disabling is achieved via software configuration. See
Section 3.6.
When Disabled: Hardware scaling is 1:1 and input impedance is
greater than 10 MΩ.
When Enabled: Hardware scaling is 50:1 and input impedance is
approximately 100 kΩ.
There are six voltage measurement ranges for analog inputs:
•
25 mV, 55 mV, 100 mV, 1 Vdc, 2.5 Vdc, and 5.0 Vdc (Applies
to both 1:1 and 50:1 scaling).
Effective voltage range in 50:1 mode:
•
1.25 Vdc, 2.75 Vdc, 5.0 Vdc, and 50 Vdc.
Each analog input can be configured to measure Bi-Polar (positive
and negative) or Uni-Polar (positive only) voltages. All analog inputs
are differential.
Each analog input can be configured to supply a 250 µA constant
current source (CCS) from the positive differential input used to
measure resistive sensors.
•
Update Rate
•
High Side Current Monitor Feature Enabled/Disabled
•
Voltage Translation Equations
•
Minimum/Maximum Values for Sensors
•
Hysteresis Value
•
Digital Filtering Value
Description/Characteristic
NOTE
Page 4-5
Revision F