Garmin GMA 1347D Посібник з монтажу - Сторінка 25

Переглянути онлайн або завантажити pdf Посібник з монтажу для Дисплей авіоніки Garmin GMA 1347D. Garmin GMA 1347D 47 сторінок.

3.6

GMA 1347D Unit Installation

Do not use excessive force when inserting the GMA 1347D into the rack. This may

damage the connectors, unit, and/or unit rack.

installation, stop! Remove the GMA 1347D and identify the source of resistance.

For final installation and assembly, refer to the outline and installation drawings shown in Appendix A of

this manual.

1. Assemble the backshell as described in Section 3.5.

2. Connect both backshells to the rear plate using the screws provided in the connector kit.

3. Mount the unit rack to a suitable mounting location on the panel using the provided nutplates.

4. Assemble the rear plate into the GMA 1347D unit rack.

5. Insert the GMA 1347D into the rack, noting proper orientation as shown on the installation

drawing in Appendix A.

6. Lock the GMA 1347D in place using the appropriate size hex wrench.

3.7

The GMA 1347D does not provide valid outputs until the aircraft post installation

configuration procedures are completed.

The GMA 1347D must be installed with a Garmin G1000 system and have FAA approved configuration

data. Configuration data is loaded to the GMA 1347D from an aircraft-specific G1000 SW Loader Card.

The G1000 PFD serves as the graphical user interface to be used by the installer that is configuring the

system. For basic configuration information, refer to the G1000 Line Maintenance and Configuration

Manual, Garmin part number 190-00303-04. For actual aircraft installation/checkout, use only aircraft

manufacturer approved checkout procedures.

3.8

Other than for regulatory periodic functional checks, maintenance of the GMA 1347D is

"on condition" only.

GMA 1347D Installation Manual

190-00303-21

CAUTION

If heavy resistance is felt during

NOTE

Page 3-3

Revision C