Garmin GPS 16 Series Посібник із швидкого старту - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Морська система GPS Garmin GPS 16 Series. Garmin GPS 16 Series 16 сторінок. Gps receiver / antenna
Також для Garmin GPS 16 Series: Декларація про відповідність (1 сторінок), Технічні характеристики (40 сторінок), Технічні характеристики (37 сторінок)

Installation

Mounting the

GPS 16

Note: As a general rule,

mount the receiver at least

three feet from all other

antennas and electrical

system components

(alternator/ignition system).

Mounting the Receiver

Please read through these instructions thoroughly before

attempting installation. Make sure you completely understand

these instructions before you begin. When in doubt, seek pro-

fessional assistance.

The following additional items are needed or optional

to complete the installation of your GPS 16:

• Receiver mount— Since mounting

locations and methods vary, you may need

to obtain a mount to install the GPS 16.

The receiver base uses either our Magnetic

Mount or may be ﬂ ush mounted.

• On/Off switch (optional)— Power to the

receiver may be controlled by an on/off switch,

such as an accessory switch on the control

console. Check with an electric supply retailer for

this item.

It is recommended that the system be temporarily

hooked up with the wiring and the unit placed at the

desired installation location. Then, check operation with

potential interfering equipment turned on and off. (For

example, other electronic equipment, fan motors, engine

ignition, alternators, generators, radars and VHF radio

transmissions can be sources of interference.)

Position the receiver so that the clearest possible view

of the sky and horizon in all directions is obtained. Avoid

mounting the receiver next to large areas of conductive

material (metal, aluminum, etc.) as this may cause poor

signal reception. The GPS 16 is supplied with a 17 foot

(5 meter) power/data cable. When routing the wiring to

the GPS 16, avoid routing the cable near an alternator

or ignition system components or parallel to other power

lines.