alkitronic CLD/L Посібник з експлуатації та технічного обслуговування - Сторінка 2
Переглянути онлайн або завантажити pdf Посібник з експлуатації та технічного обслуговування для Інструменти alkitronic CLD/L. alkitronic CLD/L 12 сторінок. Compact torque multiplier
Друкувати сторінкуOperating and maintenance manual
Introduction
We congratulate you on the purchase of a compressed air
powered alkitronic® torque multiplier. You have chosen
a high-quality product that sets new standards around
the world and meets high safety standards. To ensure this
high level, the product requires regular maintenance and
care. We therefore ask you to read these operating and
maintenance instructions carefully and to observe the
following points:
The alkitronic® Compact torque multiplier (CL) is only to
be repaired or serviced by employees of alki TECHNIK
GmbH, by those trained by alki TECHNIK GmbH or a certi-
fied service provider.
There could be a risk of damage to health and damage to
the equipment if the product is not properly maintained or
operated. In addition, any warranty claim is then forfeited.
These operating and maintenance instructions contain
basic instructions that must be observed during opera-
tion and maintenance. They must therefore be read by the
operating staff prior to commissioning or maintenance.
They must therefore always be available at the area of
application of the alkitronic® CL multiplier .
These operating and maintenance instructions refer exclu-
sively to the pneumatic alkitronic® CL multiplier.
Not only the general safety instructions listed under the
section „Labeling instructions" need to be observed but
also supplementary regulations, instructions or advice,
depending on the situation.
Definition of Symbols
Safety instructions.
Non-compliance may result in personal injury
or death.
Safety instructions.
Non-compliance may result in damage to the
alkitronic® NOVA Hydraulic Power Unit, its
functions, or the environment.
Information for proper and safe operation.
Practical advice and information to make
work easier.
Content
1.
1.1
1.2
2.
2.1
2.2
2.3
2.4
2.5
2.6
2.7
3.
3.1
Changing from standard nut / connector and
3.2
Change alkitronic® STA and
support plunger on type RCL
3.3
4.
4.1
4.2
5.
6.
2
Page
3
3
5
5
5
5
5
5
6
6
6
7
8
8
9
9
9
9
10
10
10
10
10
11