Garmin GHC 20 Посібник користувача - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник користувача для Морське обладнання Garmin GHC 20. Garmin GHC 20 13 сторінок.
Також для Garmin GHC 20: Посібник користувача (8 сторінок)

Друкувати сторінку

Tack and Gybe

You can set the autopilot to perform a tack or gybe while heading hold or wind

hold is engaged.

Tacking and Gybing from Heading Hold

Engage heading hold (page 2).

Select Menu > Tack/Gybe.

Select

to choose a direction.

The autopilot steers your boat through a tack or gybe, and the "Tacking"

displays on the heading screen until the maneuver is complete.

Tacking and Gybing from Wind Hold

NOTE: You must have a wind sensor installed before you can engage wind

hold.

Engage wind hold (page 5).

Select Menu > Tack/Gybe.

Select Tack or Gybe.

The autopilot steers your boat through a tack or gybe, and the wind hold

screen shows the compass and wind gauges with yellow highlights that

indicate the direction and progress of the tack or gybe.

Route To in the Sailboat Autopilot

CAUTION

Garmin recommends using route to only under motor power. Using route to while

under sail can cause an unexpected gybe, risking damage to your sailboat.

Unattended sails and rigging can be damaged or cause injury to any crew or

passengers during an unexpected gybe maneuver.

Device Configuration

User Autopilot Settings

Select Menu > Setup > User Autopilot Setup.

Power Mode: Sets the device power mode to normal or economy mode.

Economy power mode allows you to set the percentage of power used to run

the autopilot.

Power Saver: Sets the percentage of power used to run the autopilot when the

device is in economy power mode.

Direction Control: Sets the transmission direction of your boat (forward or

backward).

Configuring the Remote Control

You can connect one optional remote control to a the helm control.

Select Menu > Setup > Remote.

Searching for a Remote Control

Select Menu > Setup > Remote.

Select Search for Remote.

Assigning Remote Button Actions

CAUTION

If you assign a pattern to a button on the remote control, remember that you are

responsible for the safe operation of your boat. Do not begin a pattern until you

are certain the water is clear of obstacles.

NOTE: If you assign Direction Control to a button on the remote, the autopilot

must be in standby mode to change the direction (forward or reverse).

Select Menu > Setup > Remote.

Select a remote button you want to assign an action to.

Device Configuration