Garmin GHP 10V Інструкція з монтажу Посібник з монтажу - Сторінка 10

Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Морське обладнання Garmin GHP 10V. Garmin GHP 10V 20 сторінок. Marine autopilot system
Також для Garmin GHP 10V: Інструкція з монтажу Посібник з монтажу (48 сторінок), Посібник користувача (28 сторінок), Інструкція з монтажу Посібник з монтажу (20 сторінок)

To connect the GHC 10 to your existing NMEA 2000 network:

1. Determine where you would like to connect the GHC 10 to your existing NMEA 2000 network.

2. Disconnect one side of a NMEA 2000 T-connector from the network at an appropriate location.

3. If you need to extend the NMEA 2000 network backbone, connect an appropriate NMEA 2000 backbone extension cable (not included) to

the side of the T-connector you disconnected.

4. Add the included T-connector for the GHC 10 to the NMEA 2000 network by connecting it to the side of the T-connector you disconnected.

5. Route the included drop cable to the bottom of the T-connector you just added to your NMEA 2000 network. If the included drop cable is not

long enough, you can use a drop cable up to 20 ft. (6 m) long (not included).

6. Connect the drop cable to the T-connector and the GHC 10.

To connect the CCU to your existing NMEA 2000 network:

Connect the CCU to your existing NMEA 2000 network by following the procedures you used to connect the GHC 10 to your existing

NMEA 2000 network, above.

Notes:

•

Neither the CCU nor the GHC 10 is powered by the NMEA 2000 network. They must be separately connected to power sources (see

pages 7 and

9).

•

The GHC 10 must also connect to the CCU with the yellow CCU signal wire in the GHC 10 power/data cable.

•

To add additional sensors to your NMEA 2000 network, follow the instructions included with the sensors.

NMEA 000

GPS device

(not included)

Additional

drop cable

Drop cable

and

(included)

T-connector

(not included)

T-connector

(included)

Existing NMEA 000 network

Connecting the GHC 10 (and CCU) to an Existing

NMEA 2000 Network

GHC 10

Optional

Drop cable

(included)

CCU

T-connector

(included)

GHP 10V Installation Instructions