Garmin Reactor 40 Посібник з конфігурації - Сторінка 3

Переглянути онлайн або завантажити pdf Посібник з конфігурації для Морське обладнання Garmin Reactor 40. Garmin Reactor 40 8 сторінок. Mechanical
Також для Garmin Reactor 40: Інструкція з монтажу Посібник з монтажу (11 сторінок), Інструкція з монтажу Посібник з монтажу (13 сторінок), Інструкція з монтажу Посібник з монтажу (29 сторінок), Інструкція з монтажу Посібник з монтажу (25 сторінок)

Sea Trial Wizard

The Sea Trial Wizard configures the fundamental sensors on the autopilot, and it is extremely important to

complete the wizard in conditions appropriate for your boat.

Important Sea Trial Wizard Considerations

The Sea Trial Wizard must be completed in calm water. Because the nature of calm water is relative to the size

and shape of the boat, before you begin the Sea Trial Wizard, the boat must be in an appropriate location.

• The boat must not rock while sitting still or moving very slowly.

• The boat must not be significantly affected by the wind.

While completing the Sea Trial Wizard, observe these considerations.

• Weight on the boat must remain balanced. While completing any of the steps in the Sea Trial Wizard, do not

move around on the boat.

1 Drive your boat to an open area of calm water.

2 On a helm control or the autopilot screen on a chartplotter, select

Installation Setup > Wizards > Sea Trial Wizard > Begin

3 If necessary, enter the maximum speed of the boat when powered by the kicker motor only.

4 If necessary, enter 6000 as the maximum RPM value for your kicker motor.

5 Calibrate the compass

6 Perform the Autotune procedure

7 Set north

(Setting North,

page 5).

Calibrating the Compass

1 Select an option:

• If you are performing this procedure as part of the Sea Trial Wizard, select Begin.

• If you are performing this procedure outside of the Sea Trial Wizard, on a helm control or the autopilot

screen on a chartplotter, select

Compass Cal. > Begin.

2 Follow the directions until calibration is complete, taking care to keep the boat as steady and flat as

possible.

The boat should not list during calibration. Make sure one side of the vessel is not loaded more heavily than

the other.

3 Select an option:

• If the calibration is not successful, repeat the previous step.

• If the calibration completes successfully, select Next.

When the calibration is complete, a magnetic environment quality value is shown. A value of 100 indicates the

CCU was installed in a perfect magnetic environment and calibrated correctly. If this value is low, you might

need to relocate the CCU and calibrate the compass again.

(Calibrating the Compass,

(Performing the Autotune Procedure,

page 4), or set the fine heading adjustment

> Autopilot Setup > Autopilot Installation Setup > Compass Setup >

> Autopilot Setup > Autopilot

page 3).

page 4).

(Setting the Fine Heading Adjustment,