Garmin STRIKER PLUS 4 Інструкція з монтажу Посібник з монтажу - Сторінка 9
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Морське обладнання Garmin STRIKER PLUS 4. Garmin STRIKER PLUS 4 16 сторінок. Ice fishing kit
Також для Garmin STRIKER PLUS 4: Посібник користувача (16 сторінок)
Друкувати сторінку
m
[2]
m
!'!l:J
. /
@)
· " """""\ -\..
. .
"&
•.
,J~""
·-·
.
-~-
--
.
'
r ...
~
. . .,-
~...
._...,....,..,.,....,..,~
-""··
.!
~-·--
1 \
'
Tt
"'!"""
I
IIi!!
CD
Depth information
cv
Suspended targets or fish
®
Bottom of
the
body of water
Selecting the Transducer Type
If you are connecting a
transducer
that
was not included with the device, you may
need to set
the
transducer type to make
the sonar function properly. Before
connecting the transducer, you should
select the transducer type. The transducer
name should be listed on the label on
the
transducer cable, near the connector.
This device is compatible with a range of
accessory transducers, including Garmin
ClearVu transducers, which are available
at www.garmin.com/transducers.
1
Select
Settings> My
Vessel>
Transducer
Type.
2
Select an option:
•
If you have a 200/77 kHz, dual"
beam transducer, select
Dual
Beam
(200/77
kHz).
•
If you have a 200/50 kHz, dual"
frequency transducer, select
Dual
Frequency (200/50 kHz).
•
If you have another type of
transducer, select it from the list.
Sonar Frequencies
NOTE:
The frequencies that are available
depend on the transducer being used.
Adjusting the frequency helps adapt the
sonar for your particular goals and the
present depth of the water.
Selecting Frequencies
NOTE:
You cannot adjust the frequency
for all sonar views and transducers.
You can indicate which frequencies
appear on the sonar screen
.
1
From a sonar view, select=>
Frequency.
2
Select a frequency suited
to
your
needs and water depth.
Creating a Waypoint on the Sonar
Screen Using the Device Keys
1
From a sonar view, use the arrow
keys to select a location to save.
2
Select-/.
3
If necessary, edit the waypoint
information.
Navigation
Marking Your Present Location as
a Waypoint
From any screen, select£.
Navigating to a Waypoint
1
From the
Quickdraw
Map, use the
arrow keys to select the waypoint.
The waypoint name appears on the
screen.
2
Select-/.
3
Select
Navigate To>
Go
To.
Creating and Navigating a Route
Using the Map
The starting point can be your present
location or another location on the map.
1
Select
User Data
>
Routes
> New >
Route Using
Chart.
2
Pan the map to select the starting
location of the route.
3
Select
-1
to add a turn to the route.
4
Repeat to add all of the turns in the
route.
5
Select=>
Navigate To.
-
-
-
-~
-
·
-
-
-
--
4
Quick Start Manual